INSTRUCTION AND MAINTENANCE MANUAL FOR JABIRU 2200 ...

Jabiru Aircraft Pty LtdInstruction & Maintenance ManualJabiru 2200 Aircraft EngineHydraulic Valve Lifter ModelsC61. Clean and visually inspect2. Mount cylinders in honing machine by base and hone with Sunnen mm 33-J85 Stone3. Measure and record in Build Sheet4. Bead blast cylinder outer to remove all old paint and rust.5. Etch prime and paint with high temperature paint.6. Run 5/16 UNF Tap through head threads to remove all beads and to insurethat head bolts torque up fully.7. Clean in kerosene then in hot soapy water to remove all honing oil etc.Note: Once cleaned, oil up cylinders straight away. Store in a cool dry place in asealed container.Figure 21. Drawing 9436064 – Barrel HoneC7C8Pistons1. Clean oil out of pistons2. Dip Pistons in cold dip solvent (i.e. Redik DKT degreaser – decarboniserpaint stripper) as per manufacturers instructions to remove all carbon.Note: The head of the piston can be bead blasted, but never bead blast the ringgrooves, piston skirt and piston pin bores.3. Use an old ring to clean carbon out of ring grooves but care must be takennot to scratch grooves. Any scratching will cause Gas Leakage past therings. A piece of 2mm (0.080") perspex can also be used as it is kinder tothe pistons.1. Clean thoroughly.2. Visually inspect pistons for cracks or damage.3. Measure pistons and record in build sheet.4. Check circlip groove.NOTE: Top ring has uninterrupted vertical edge. 2 nd Ring has 2 cut-aways onvertical face (Top and Bottom). Ring manufacturers will specify machinings andorientation of first and second rings.This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.REVISION 0 1 2 3 4 5 6 7 8 9 Dated : June 2010 Issued By: DPS Page: 53 of 116L:\files\Manuals_For_Products\Engine_Manuals\Transition\JEM2204-9_I&M_unsigned.docx