INSTRUCTION AND MAINTENANCE MANUAL FOR JABIRU 2200 ...

Jabiru Aircraft Pty LtdInstruction & Maintenance ManualJabiru 2200 Aircraft EngineHydraulic Valve Lifter Models6.12 Engine Inspection ChartNote: READ ALL INSPECTION RQUIREMENTS PARAGRAPHS PRIOR TOUSING THESE CHARTS.Annual InspectionEach 100 HoursEach 50 HoursPROPELLER1 Spinner * *2 Spinner Flange * *3 Spinner screws * *4 Propeller * *5 Propeller bolts/nuts - Tension * *6 Spinner / Prop Tracking * *ENGINE & ENGINE COMPARTMENTCheck for oil, fuel exhaust & induction leaks, thenclean entire engine & compartment beforeinspection. Check flywheel screw tensions to 24lb.ft 1 , 2 *Carburetor air filter –Check & replace if required* * * Engine baffles and air ducts * Cylinders * Crankcase & front crankcase seal * Fuel hoses, lines and fittings * * Intake and exhaust systems *1 Note: if any screws rotate they must be removed, cranckshaft and screw threads cleanedthen re-installed with fresh Loctite 620 (Use no more than the size of a match head). Donot remove all flywheel screws at once or loss of valve timing may occur.2 Up to engine S/No. 2732 – not required on engines with the “starfish” steel flywheeladaptor plateThis document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.REVISION 0 1 2 3 4 5 6 7 8 9 Dated : June 2010 Issued By: DPS Page: 35 of 116L:\files\Manuals_For_Products\Engine_Manuals\Transition\JEM2204-9_I&M_unsigned.docx