AT-15 HD 16 Owners Manual - American Tactical Imports
AT-15 HD 16 Owners Manual - American Tactical Imports AT-15 HD 16 Owners Manual - American Tactical Imports
PREVENTATIVE MAINTENANCE CHECKS & SERVICES…CHECK BEFORE YOU FIRE!...1.) Check to see that there is NO EXCESSIVE OILin the Bore. If there is, swab it out with apatch and the cleaning rod. ALWAYS CLEANA NEW RIFLE BEFORE FIRING.WARNING! If the rifle is fired with oil - orwater - in the barrel, excessive pressure willbe created causing the rifle to explode.2.) Retract the Bolt to ensure free movementbetween Bolt Carrier and Gas Tube.3.) Perform Safety Function Check (below) to ensure that Safety Selector Lever works properly.SAFETY FUNCTION CHECK…UNLOAD RIFLE - REMOVE MAGAZINE - CHECK CHAMBER1.) Remove Magazine if installed. Pull Charging Handle assemblyto rear. Check that Chamber is clear. Let the Bolt and BoltCarrier close. Do not pull Trigger. Leave Hammer in cockedposition.WARNING! If Rifle fails any of the following tests, continued useof the Rifle could result in injury to, or death of, people aroundyou.2.) Place Selector Lever in SAFE position, point rifle ina safedirection, and pull Trigger. THE HAMMER SHOULD NOT FALL.Continued on next page...PAGE 5Manufactured by Head Down Products
ABOUT YOUR HEAD DOWN RIFLE...This Operating Manual covers all Head Down XPR15 models chambered for 5.56mmNATO/.223 Remington ammunition. They are lightweight, gas operated, air-cooled,magazine-fed rifles, carbines that are Semi-Automatic in operating mode (i.e., a singleround will fire each time the trigger is pulled). Note: For Law Enforcement and Militarymarkets, Head Down makes similar models in either Full-Automatic (continuous fire aslong as the trigger is pulled) or Three Round Burst (a group of 3 shots will fire as longas the trigger is pulled) configurations. Sales of these models require special permitsand are regulated by ATF.On all models, the Upper And Lower Receivers are easily opened for cleaning and inspection.XPR15 Models have billet aluminum Upper and Lower Receivers.Barrels on XPR15 Models are either chrome lined Chrome Moly Vanadium Steel or416 Stainless Steel. They are usually button rifled 1 turn in 7” with a right hand twist.All models can be configured with either 6 position Telescoping Buttstocks or solid A2“Trapdoor” Buttstocks. Forends are of removable split design and are vented to allowheat dissipation. All models feature detachable magazines. Magazine capacity is 30 roundsstandard (depending on State Regulations), but all AR-15/M-16 Type magazines of capacitiesfrom 5 to 40 rounds will fit the XPR15 and function in it.PAGE 3Manufactured by Head Down Products
- Page 1 and 2: TMAmerican TacticalHD-16Manufacture
- Page 3: PLEASE PRACTICE SAFE FIREARMS HANDL
- Page 7 and 8: PREVENTATIVE MAINTENANCE CHECKS & S
- Page 9 and 10: OPERATION OF YOUR RIFLE… LOADINGC
- Page 11 and 12: OPERATION OF YOUR RIFLE… (CONTINU
- Page 13 and 14: IMMEDIATE ACTIONS — IN CASE OF TR
- Page 15 and 16: BULLET STUCK IN THE BORE…WARNING:
- Page 17 and 18: DISASSEMBLING YOUR RIFLE… (Contin
- Page 19 and 20: DISASSEMBLING YOUR RIFLE… (Contin
- Page 21 and 22: INSPECTION — CLEANING — LUBRICA
- Page 23 and 24: CLEANING THE UPPER RECEIVER…NOTE:
- Page 25 and 26: CLEANING THE LOWER RECEIVER…1.) C
- Page 27 and 28: LUBRICATION - BOLT CARRIER GROUP…
- Page 29 and 30: REASSEMBLING YOUR RIFLE… (Continu
- Page 31 and 32: REASSEMBLING YOUR RIFLE… (Continu
- Page 33 and 34: PROBLEMS / SOLUTIONS…PROBLEM CHEC
- Page 35 and 36: PROBLEMS / SOLUTIONS…PROBLEM CHEC
- Page 37 and 38: COLD WEATHER SHOOTING…If cold wea
- Page 39 and 40: LIMITED MANUFACTURERS WARRANTYHead
ABOUT YOUR HEAD DOWN RIFLE...This Operating <strong>Manual</strong> covers all Head Down XPR<strong>15</strong> models chambered for 5.56mmN<strong>AT</strong>O/.223 Remington ammunition. They are lightweight, gas operated, air-cooled,magazine-fed rifles, carbines that are Semi-Automatic in operating mode (i.e., a singleround will fire each time the trigger is pulled). Note: For Law Enforcement and Militarymarkets, Head Down makes similar models in either Full-Automatic (continuous fire aslong as the trigger is pulled) or Three Round Burst (a group of 3 shots will fire as longas the trigger is pulled) configurations. Sales of these models require special permitsand are regulated by <strong>AT</strong>F.On all models, the Upper And Lower Receivers are easily opened for cleaning and inspection.XPR<strong>15</strong> Models have billet aluminum Upper and Lower Receivers.Barrels on XPR<strong>15</strong> Models are either chrome lined Chrome Moly Vanadium Steel or4<strong>16</strong> Stainless Steel. They are usually button rifled 1 turn in 7” with a right hand twist.All models can be configured with either 6 position Telescoping Buttstocks or solid A2“Trapdoor” Buttstocks. Forends are of removable split design and are vented to allowheat dissipation. All models feature detachable magazines. Magazine capacity is 30 roundsstandard (depending on State Regulations), but all AR-<strong>15</strong>/M-<strong>16</strong> Type magazines of capacitiesfrom 5 to 40 rounds will fit the XPR<strong>15</strong> and function in it.PAGE 3Manufactured by Head Down Products