AT-15 HD 16 Owners Manual - American Tactical Imports
AT-15 HD 16 Owners Manual - American Tactical Imports AT-15 HD 16 Owners Manual - American Tactical Imports
DISASSEMBLING YOUR RIFLE…1.) CLEAR YOUR RIFLE! (as described on Page 7).2.) Push in Takedown Pin (a Bullet tip canhelp) as far as it will go. Pivot UpperReceiver from Lower Receiver.3.) Push in Pivot Pin (a Bullet tip can help).4.) Separate Upper and Lower Receivers.5.) Pull back Charging Handle and BoltCarrier.PAGE 14Manufactured by Head Down Products
DISASSEMBLING YOUR RIFLE… (Continued)6.) Remove Bolt Carrier and Bolt.9.) Drop Firing Pin out of rear of Bolt Carrier.7.) Remove Charging Handle by pulling back andup until “Ears” clear cutouts in Receiver.8.) Remove Firing Pin Retaining Pin. A Bullet tipcan help push it out of the Bolt Carrier.Do Not open or close split end of Firing PinRetaining Pin, and Do Not substitute acommon cotter pin on reassembly.PAGE 15Manufactured by Head Down Products
- Page 1 and 2: TMAmerican TacticalHD-16Manufacture
- Page 3 and 4: PLEASE PRACTICE SAFE FIREARMS HANDL
- Page 5 and 6: ABOUT YOUR HEAD DOWN RIFLE...This O
- Page 7 and 8: PREVENTATIVE MAINTENANCE CHECKS & S
- Page 9 and 10: OPERATION OF YOUR RIFLE… LOADINGC
- Page 11 and 12: OPERATION OF YOUR RIFLE… (CONTINU
- Page 13 and 14: IMMEDIATE ACTIONS — IN CASE OF TR
- Page 15: BULLET STUCK IN THE BORE…WARNING:
- Page 19 and 20: DISASSEMBLING YOUR RIFLE… (Contin
- Page 21 and 22: INSPECTION — CLEANING — LUBRICA
- Page 23 and 24: CLEANING THE UPPER RECEIVER…NOTE:
- Page 25 and 26: CLEANING THE LOWER RECEIVER…1.) C
- Page 27 and 28: LUBRICATION - BOLT CARRIER GROUP…
- Page 29 and 30: REASSEMBLING YOUR RIFLE… (Continu
- Page 31 and 32: REASSEMBLING YOUR RIFLE… (Continu
- Page 33 and 34: PROBLEMS / SOLUTIONS…PROBLEM CHEC
- Page 35 and 36: PROBLEMS / SOLUTIONS…PROBLEM CHEC
- Page 37 and 38: COLD WEATHER SHOOTING…If cold wea
- Page 39 and 40: LIMITED MANUFACTURERS WARRANTYHead
DISASSEMBLING YOUR RIFLE… (Continued)6.) Remove Bolt Carrier and Bolt.9.) Drop Firing Pin out of rear of Bolt Carrier.7.) Remove Charging Handle by pulling back andup until “Ears” clear cutouts in Receiver.8.) Remove Firing Pin Retaining Pin. A Bullet tipcan help push it out of the Bolt Carrier.Do Not open or close split end of Firing PinRetaining Pin, and Do Not substitute acommon cotter pin on reassembly.PAGE <strong>15</strong>Manufactured by Head Down Products