AT-15 HD 16 Owners Manual - American Tactical Imports
AT-15 HD 16 Owners Manual - American Tactical Imports AT-15 HD 16 Owners Manual - American Tactical Imports
OPERATION OF YOUR RIFLE… (CONTINUED)CONDITION: Rifle is now Loaded, a Round is Chambered, and Safety Selector should be on SAFE.CAUTION: ALWAYS POINT THE MUZZLE IN A SAFE DIRECTION!To FIRE the Rifle in SEMI-AUTOMATIC MODE (one Round firedwith each pull of the Trigger), move the Safety Selector fromSAFE to FIRE.Aim at Target – Pull Trigger – Release.The Rifle will automatically eject the spent Cartridge andchamber another in preparation for the next shot. The cycle ofpulling the Trigger to shoot, and the Rifle automaticallyreloading, can be continued until the Magazine is empty.NOTE: After the last Round is fired, the Bolt Carrier will lock inthe rear position. You can then push the Magazine ReleaseButton to drop out the empty magazine, insert a fresh Magazine,release the Bolt Catch, and a new Round will be automaticallychambered in preparation for the next firing sequence.WARNING… IF A NOTICEABLE DIFFERENCE IN SOUND OR RECOIL ISEXPERIENCED, STOP FIRING. Either condition could indicate an incompletepowder burn and/or a bullet stuck in the bore. Retract the Bolt slowly andremove the fired cartridge case. Clear the weapon and check for unburnedpowder grains in the Receiver or Bore, and for a Bullet stuck in the Bore(see Page 17). Clean out any unburned powder before resuming firing. If aBullet is stuck in the Bore, do not attempt to remove it. Take the Rifle to aqualified Gunsmith.PAGE 10Manufactured by Head Down Products
IMMEDIATE ACTIONS — IN CASE OF TROUBLE! (CONT’D)CAUTION: ALWAYS POINT THE MUZZLE IN A SAFE DIRECTION!3.) If Cartridge or Case is ejected, or Chamber isclear, RELEASE Charging Handle to feed a newRound. Don’t “ride” the Charging Handle forward.4.) Tap Forward Assist to ensure Boltis locked.5.) Now FIRE.If the Rifle will not fire, look fortrouble and apply the RemedialActions described on the next Page.PAGE 11Manufactured by Head Down Products
- Page 1 and 2: TMAmerican TacticalHD-16Manufacture
- Page 3 and 4: PLEASE PRACTICE SAFE FIREARMS HANDL
- Page 5 and 6: ABOUT YOUR HEAD DOWN RIFLE...This O
- Page 7 and 8: PREVENTATIVE MAINTENANCE CHECKS & S
- Page 9 and 10: OPERATION OF YOUR RIFLE… LOADINGC
- Page 11: OPERATION OF YOUR RIFLE… (CONTINU
- Page 15 and 16: BULLET STUCK IN THE BORE…WARNING:
- Page 17 and 18: DISASSEMBLING YOUR RIFLE… (Contin
- Page 19 and 20: DISASSEMBLING YOUR RIFLE… (Contin
- Page 21 and 22: INSPECTION — CLEANING — LUBRICA
- Page 23 and 24: CLEANING THE UPPER RECEIVER…NOTE:
- Page 25 and 26: CLEANING THE LOWER RECEIVER…1.) C
- Page 27 and 28: LUBRICATION - BOLT CARRIER GROUP…
- Page 29 and 30: REASSEMBLING YOUR RIFLE… (Continu
- Page 31 and 32: REASSEMBLING YOUR RIFLE… (Continu
- Page 33 and 34: PROBLEMS / SOLUTIONS…PROBLEM CHEC
- Page 35 and 36: PROBLEMS / SOLUTIONS…PROBLEM CHEC
- Page 37 and 38: COLD WEATHER SHOOTING…If cold wea
- Page 39 and 40: LIMITED MANUFACTURERS WARRANTYHead
OPER<strong>AT</strong>ION OF YOUR RIFLE… (CONTINUED)CONDITION: Rifle is now Loaded, a Round is Chambered, and Safety Selector should be on SAFE.CAUTION: ALWAYS POINT THE MUZZLE IN A SAFE DIRECTION!To FIRE the Rifle in SEMI-AUTOM<strong>AT</strong>IC MODE (one Round firedwith each pull of the Trigger), move the Safety Selector fromSAFE to FIRE.Aim at Target – Pull Trigger – Release.The Rifle will automatically eject the spent Cartridge andchamber another in preparation for the next shot. The cycle ofpulling the Trigger to shoot, and the Rifle automaticallyreloading, can be continued until the Magazine is empty.NOTE: After the last Round is fired, the Bolt Carrier will lock inthe rear position. You can then push the Magazine ReleaseButton to drop out the empty magazine, insert a fresh Magazine,release the Bolt Catch, and a new Round will be automaticallychambered in preparation for the next firing sequence.WARNING… IF A NOTICEABLE DIFFERENCE IN SOUND OR RECOIL ISEXPERIENCED, STOP FIRING. Either condition could indicate an incompletepowder burn and/or a bullet stuck in the bore. Retract the Bolt slowly andremove the fired cartridge case. Clear the weapon and check for unburnedpowder grains in the Receiver or Bore, and for a Bullet stuck in the Bore(see Page 17). Clean out any unburned powder before resuming firing. If aBullet is stuck in the Bore, do not attempt to remove it. Take the Rifle to aqualified Gunsmith.PAGE 10Manufactured by Head Down Products