DENTEXÂ® Operating / Installation manual BMA0008 - RAJA-Lovejoy

More documents

Recommendations

Info

Raja-Lovejoy GmbH DENTEX® Number: BMA0008Friedrichstr. 6 operating / Page: 7 of 14D-58791 Werdohl installation manual Version: 1ENGFigure 3: Diagram of the DENTEX® tooth coupling, series B3R with internal andexternal Seeger ringsTable 3: Dimensions of the DENTEX® tooth coupling, series B3RDENTEX® tooth couplinges used with other add-on parts which couldproduce heat, sparks and static charges (e.g. JOYTORK safetycouplinges) are not approved for use in Ex-zones. These must be testedin advance.Copyright reserved Signed: 05.10.2010 MBOZ Replacement for:as per ISO 16016 Checked: 01.04.2011 JZIS Replaced by:
Raja-Lovejoy GmbH DENTEX® Number: BMA0008Friedrichstr. 6 operating / Page: 8 of 14D-58791 Werdohl installation manual Version: 1ENG5.0 Assembly5.1 Assembly instructionsWe recommend checking the dimensional accuracy of the hole, shaft, slotand feather key before commencing assembly.Gently heating the hubs to approx. 80°C makes it easier to fit them onto theshaft.Touching the heated coupling hubs can cause burns. Wear safety glovesDuring assembly, make sure that dimension E, see Tables 1-3, is adhered to,so that the coupling sleeve can still move axially during use. If this instructionis not observed, the coupling cannot work properly and may be damaged.It is vital that you pay attention to hazards from ignition sources in areaswhere there is a risk of explosion!5.2 Components of the couplingFigure 4: DENTEX® tooth coupling - assemblyCopyright reserved Signed: 05.10.2010 MBOZ Replacement for:as per ISO 16016 Checked: 01.04.2011 JZIS Replaced by:
Page 2 and 3: Company Name:______________________
Page 4 and 5: Raja-Lovejoy GmbH DENTEX® Number:
Page 7: Raja-Lovejoy GmbH DENTEX® Number:
Page 15: Raja-Lovejoy GmbH DENTEX® Number:

DENTEXÂ® Operating / Installation manual BMA0008 - RAJA-Lovejoy

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?