CEMB C72 Parts List

5.3 - RECALCULATION OF THE UNBALANCEPressafter new setting of the measurement5.4 - RESULT OF MEASUREMENTFig. 13Inside correctionOutside correctionAfter performing a balancing spin, the amounts of unbalance are shown on the digital readouts.When the matrix display is ON, this indicates the correct angular wheel position for fi ttingcounterweights. (12 o’clock position). When the beep signal is enabled (see section CONTROLOF THE FUNCTIONS MENU), this is activated when the wheel reaches the correction position.If the unbalance is less than the threshold selected, is displayed instead of the unbalance, with itis possible to read the values below the threshold chosen gram by gram.If the static unbalance is greater than 30 gr., the OPT Led fl ashes to suggest an unbalance optimisationoperation. (see UNBALANCE OPTIMIZATION)5.4.1 - INDICATION OF EXACT CORRECTION POSITION IN ALU-SIn correction mode ALU-S it is possible to cancel approximations in the mountingof the counterweights by proceeding as follows:- press- Insert the correct weight on the relative seat on the weight holder pincers- Remove the gauge when the display shows:to indicate that the gauge should be pulled further outto indicate that the gauge should be returned to rest positionThe left display gives the indications for reaching the position regarding the inside, while the right displaythat of the outsideThe position of the gauge is also indicated by the position repeater Led (8).Positionreached onthe internalsideFig. 14I 0226 GB- 15