WatchGuard Firebox System 7.0 User Guide

Setting IP Addresses of Firebox InterfacesSetting addresses in drop-in modeIf you are using drop-in mode, all interfaces use the sameIP address:1 Select Network => Configuration.The Network Configuration dialog box appears, as shown in thefollowing figure.2 Select the Configure interfaces in Drop-In modecheckbox, located at the bottom of the dialog box.3 Enter the IP address and default gateway for theFirebox interfaces.When typing IP addresses, type the digits and periods insequence. Do not use the TAB or arrow key to jump past theperiods. For more information on entering IP addresses, see“Entering IP addresses” on page 43.If you are using static PPPoE on your external interface, you alsoneed to enter your PPP user name and password. For moreinformation on PPPoE support, see “Dynamic IP support on theexternal interface” on page 35.User Guide 59