WatchGuard Firebox System 7.0 User Guide

Appendix A: Troubleshooting Firebox Connectivity2 Power-cycle the Firebox. The light sequence shouldlook like this:Armed light: SteadySys B: Steady (On some Fireboxes, the Sys B light may flicker.)(Do not be concerned with the lights on the Security TriangleDisplay indicating traffic between interfaces.)3 Take out one end of the serial cable from the Firebox tobreak the loop effect.4 On the management station, open a DOS prompt. Pingthe Firebox with a 192.168.253.1.You should get a reply.5 In Policy Manager, select File => Open =>Configuration File. Select the configuration file youwant to load onto the Firebox and load it into PolicyManager.6 In Policy Manager, select File => Save => To Firebox.When you are prompted for an IP address, use192.168.253.1 with wg as the passphrase.7 When the Firebox Flash Disk dialog box appears,select the button marked Save Configuration File andNew Flash Image.8 After the file has been restored on the Firebox, you willhave to reassign the IP address of your managementstation such that it is on the same network as thetrusted interface from the configuration file that youjust used. This will enable you to reconnect to theFirebox with the trusted IP address that is listed in theconfiguration file and your status passphrase.278 WatchGuard Firebox System