WatchGuard Firebox System 7.0 User Guide

Method 4: Serial Dongle (Firebox II only)6 In Policy Manager, select File => Save => To Firebox.When you are asked for the IP address of the Firebox,use 192.168.253.1 with wg as the passphrase.7 When the Firebox Flash Disk dialog box appears, clickthe button marked Save Configuration File and NewFlash Image.8 After the file has been restored on the Firebox, you willhave to reassign the IP address of your managementstation such that it is on the same network as thetrusted interface from configuration file that you justused. This will enable you to reconnect to the Firebox.After the configuration has been uploaded and the Fireboxhas been rebooted, the Firebox light sequence should nowlook like this:Armed light: steadySys A light: steadyMethod 4: Serial Dongle (Firebox II only)This option requires you to use a serial cable and a crossovercable. As with the previous procedures, you must disconnectyour management station and Firebox from thenetwork.Make sure that the management station is configured to beon the same network as 192.168.253.0. Do not use the192.168.253.1 address, which is being held by the Fireboxas a default.1 Connect one end of the serial cable to the serial port ofthe Firebox and the other end to the console port of theFirebox. Place the crossover cable into the trustedinterface and into the management station.User Guide 277