ncr/doc/Kiosks/TechnicalManuals/7401_Kiosk_Sit... - Alsys Data

50 Site PreparationInstallation Guidelines• To prevent moisture from entering system, the front of the displaymust be in close contact with the opening in the enclosure.• Within every custom enclosure, the Electronics Box Back CoverMUST remain installed because it helps dissipate the heatgenerated by the CPU.• Adequate ventilation must be provided in every custom enclosure.The maximum allowable ambient temperature within anyenclosure is 45 o C (113 o F).• To prevent accidental shorts, the power supply and any otherperipheral within the enclosure must be mounted securely andwithin reach of the display’s connectors.• This feature comes with a motion sensor that is at the end of a381 mm (15 in.) cable. When using the motion sensor, it must bemounted between 25 and 76 mm (1 to 3 in.) below the bottom of thedisplay and centered along the width of the display.• Compliance of this device with regulatory requirements must beverified in the end-use application.• This device is a component that requires a suitable enclosure in itsend-use application. The end-use product in which this componentis used should be certified in accordance with UL 1950, EN60950,IEC950 or other applicable safety standard.Caution: NCR displays are not designed for horizontal or inverteduse. NCR displays must be mounted no more than 40 o forward orbackward from horizontal. Failure to follow this guideline could resultin overheating.