ncr/doc/Kiosks/TechnicalManuals/7401_Kiosk_Sit... - Alsys Data

More documents

Recommendations

Info

The products described in this book are licensed products of NCR Corporation.NCR is a registered trademark of NCR Corporation.NCR EasyPoint and RealPOS are registered trademarks of NCR Corporation in the United States and/orother countries.Pentium and Celeron are registered trademarks of Intel Corporation.It is the policy of NCR Corporation (NCR) to improve products as new technology, components, software,and firmware become available. NCR, therefore, reserves the right to change specifications without priornotice.All features, functions, and operations described herein may not be marketed by NCR in all parts of theworld. In some instances, photographs are of equipment prototypes. Therefore, before using this document,consult with your NCR representative or NCR office for information that is applicable and current.To maintain the quality of our publications, we need your comments on the accuracy, clarity, organization,and value of this book.Address correspondence to:Manager, Information ProductsNCR Corporation2651 Satellite Blvd.Duluth, GA 30096Copyright © 2002By NCR CorporationDayton, Ohio U.S.A.All Rights Reserved
Site PreparationiPrefaceSafety RequirementsThis is a contractual document. It contains important warnings andconfers important legal rights and obligations. You are advised to readit carefully.It is the responsibility of the customer to assure that all installationpreparations are complete and in compliance with NCR specificationsand requirements and all applicable national, state, or local codes,regulations, and laws.ServicingCaution: This product does not contain user serviceable parts.Servicing should only be performed by a qualified service technician.Fuse ReplacementCaution: For continued protection against risk of fire, replace onlywith the same type and ratings of fuse.Attention: Pour prévenir et vous protéger contre un risque de feu,remplacer la fusible avec une autre fusible de même type, seulement.Power Supply Cord Used as Disconnect MeansCaution: The power supply cord is used as the main disconnectdevice. Ensure that the socket outlet is located/installed near theequipment and is easily accessible.Attention: Le cordon d'alimentation est utilisé comme interrupteurgénéral. La prise de courant doit être située ou installée å proximité dumatériel et être facile d'accés.Lithium Battery WarningCaution: Danger of explosion if battery is incorrectly replaced.Replace only with the same or equivalent type as recommended by themanufacturer. Discard used batteries according to the manufacturer'sinstructions.
Page 1: N CRNCR EasyPoint 7401Release 2.5Si
Page 5 and 6: Site PreparationiiiAbout this BookG
Page 7 and 8: Site PreparationvReferences• NCR
Page 9 and 10: Site PreparationviiTable of Content
Page 11 and 12: Site PreparationixCable Routing Con
Page 13 and 14: Site PreparationxiRevision RecordIs
Page 15 and 16: Site PreparationxiiiInternational R
Page 17 and 18: Site PreparationxvDeclaration of Co
Page 19 and 20: Site PreparationIntroduction7401-2x
Page 21 and 22: Site Preparation 3Interpreting the
Page 23 and 24: Site Preparation 5Customer Responsi
Page 25 and 26: Site Preparation 77401-2xxx and 3xx
Page 27 and 28: Site Preparation 97401-2xxx and 3xx
Page 29 and 30: Site Preparation 11Operating and Se
Page 31 and 32: Site Preparation 137401-22xx/26xx T
Page 33 and 34: Site Preparation 157401-25xx/26xx (
Page 35 and 36: Site Preparation 177401-K540 (12.1
Page 37 and 38: Site Preparation 197401-K580/590 w/
Page 39 and 40: Site Preparation 217401 with 2336-K
Page 41 and 42: Site Preparation 23EasyPoint 45 Ped
Page 43 and 44: Site Preparation 25NCR 2189 Cash Dr
Page 45 and 46: Site Preparation 277196 Thermal Rec
Page 47 and 48: Site Preparation 29Component Weight
Page 49 and 50: Site Preparation 317401 Power Requi
Page 51 and 52: Site Preparation 33Power Consumptio
Page 53 and 54:
Site Preparation 35Cable Routing Co
Page 55 and 56:
Site Preparation 377401-4xxxExterna
Page 57 and 58:
Site Preparation 39Terminal with K5
Page 59 and 60:
Site Preparation 41Terminal with K5
Page 61 and 62:
Site Preparation 43Lag Screws (6)1.
Page 63 and 64:
Site Preparation 45Printer Only Mou
Page 65 and 66:
Site Preparation 47Considerations f
Page 67 and 68:
Site Preparation 4912.1-inch LCD No
Page 69 and 70:
Site Preparation 51Mounting Specifi
Page 71 and 72:
Site Preparation 53Mounting Specifi
Page 73 and 74:
Site Preparation 55K/F 502 Flush Wa
Page 75 and 76:
Site Preparation 577401-4xxx Mounti
Page 77 and 78:
Site Preparation 597401-4xxx EasyPo
Page 79 and 80:
Site Preparation 61System CablesCab
Page 81 and 82:
Site Preparation 63Cable Illustrati
Page 83 and 84:
Site Preparation 65External Paralle
Page 85 and 86:
Appendix A: Transient ProtectionAC
Page 87 and 88:
Index—1—12.1 Inch LCD No-Cabine
Page 90:
B005-0000-1255 Dec 2002 Printed on
show all

ncr/doc/Kiosks/TechnicalManuals/7401_Kiosk_Sit... - Alsys Data

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?