iG5A, product manual - H2flow

• Input/Output GroupLEDdisplayAddressforcommunicationParameter nameMin/MaxrangeDescriptionFactorydefaultsAdj.duringrunPageI56 A438 [Faultrelayoutput]0 ~ 7Whensetting theH26–[Number ofautorestart try]When thetrip otherthan lowvoltage tripoccursWhen thelow voltagetrip occurs2 O 9-7Bit 2 Bit 1 Bit 00 - - -1 - - 2 - -3 - 4 - -5 - 6 -7 I57 A439 [Outputterminalselectwhencommunicationerroroccurs]0 ~ 3Multi-functionrelayMulti-functionoutput terminalBit 1 Bit 00 - -1 - 2 -0 O 9-123 I59 A43B [Communicationprotocolselect]0 ~ 1Set communication protocol.0 Modbus RTU1 LS BUS0 X 11-2I60 A43C [Inverternumber]I61 A43D [Baudrate]I62 A43E [Drivemodeselectafterloss offrequencycommand]I63 A43F [Waittimeafterloss offrequencycommand]1 ~ 250 Set for RS485 communication 1 O 11-20 ~ 40 ~ 20.1 ~ 120[sec]Select the Baud rate of the RS485.0 1200 [bps]1 2400 [bps]2 4800 [bps]3 9600 [bps]4 19200 [bps]It is used when freq command is given viaV1 /I terminal or RS485.0 Continuous operation at the frequencybefore its command is lost.1 Free Run stop (Output cut-off)2 Decel to stopThis is the time inverter determineswhether there is the input frequencycommand or not. If there is no frequencycommand input during this time, inverterstarts operation via the mode selected atI62.3 O 11-20 O 10-71.0 O 10-75-23