iG5A, product manual - H2flow

• Function group 2LEDdisplayAddress forcommunicationParameternameH17 A311 [S-Curveaccel/decelstart side]H18 A312 [S-Curveaccel/decelend side]H19 A313 [Input/outputphase lossprotectionselect]H20 A314 [Power OnStart select]Min/Maxrange1~100[%]1~100[%]DescriptionSet the speed reference value to form acurve at the start during accel/decel. If it isset higher, linear zone gets smaller.Set the speed reference value to form acurve at the end during accel/decel. If it is sethigher, linear zone gets smaller.0 ~ 3 0 Disabled 1 Output phaseprotection2 Inputphaseprotection3 Input/output phaseprotection0 ~ 1 This parameter is activated when drv is set to1 or 2 (Run/Stop via Control terminal).Motor starts acceleration after AC power isapplied while FX or RX terminal is ON.Factorydefaults40 X40 XAdj.duringrunPage7-150 O 10-40 O 7-11H21 A315 [Restartafter faultresetselection]0 ~1 This parameter is activated when drv is set to1 or 2 (Run/Stop via Control terminal).Motor accelerates after the fault condition isreset while the FX or RX terminal is ON.0 O 7-11H221)[SpeedSearchSelect]0 ~ 15This parameter is active to prevent anypossible fault when the inverter outputs itsvoltage to the running motor.1. H20-[PowerOn start]2.Restartafterinstantpowerfailure3.Operationafter fault4.Normalaccel0 O 8-17Bit 3 Bit 2 Bit 1 Bit 00 - - - -1 - - - 2 - - -3 - - 4 - - -1)Normal acceleration has first priority. Even though #4 is selected along with other bits, Inverter performs Speed search#4.5-10