iG5A, product manual - H2flow

• Function group 1LEDdisplayF511)AddressforcommunicationA233Parametername[Electronicthermallevel for 1minute]F52 A234 [Electronicthermallevel forcontinuous]F53 A235 [Motorcoolingmethod]F54 A236 [Overloadwarninglevel]F55 A237 [Overloadwarningtime]F56 A238 [Overloadtrip select]F57 A239 [Overloadtrip level]F58 A23A [Overloadtrip time]Min/Maxrange50 ~ 200[%]50 ~ 150[%]0 ~ 130 ~ 150[%]DescriptionThis parameter sets max current capable offlowing to the motor continuously for 1 minute.The set value is the percentage of H33 –[Motor rated current].It cannot be set below F52 –[Electronic thermallevel for continuous].This parameter sets the amount of current tokeep the motor running continuously.It cannot be set higher than F51 – [Electronicthermal level for 1 minute].0 Standard motor having cooling fandirectly connected to the shaft1 A motor using a separate motor topower a cooling fan.This parameter sets the amount of current toissue an alarm signal at a relay or multifunctionoutput terminal (see I54, I55).The set value is the percentage of H33- [Motorrated current].0 ~ 30 [Sec] This parameter issues an alarm signal whenthe current greater than F54- [Overloadwarning level] flows to the motor for F55-[Overload warning time].0 ~ 1 This parameter turns off the inverter outputwhen motor is overloaded.30 ~ 200[%]1) : Set F50 to 1 to display this parameter.This parameter sets the amount of overloadcurrent.The value is the percentage of H33- [Motorrated current].0 ~ 60 [Sec] This parameter turns off the inverter outputwhen the F57- [Overload trip level] of currentflows to the motor for F58- [Overload trip time].Factorydefaults150 0100 00 0150 010 01 0180 060 0Adj.duringrunPage10-110-210-25-6