iG5A, product manual - H2flow

• Drive GroupLEDdisplayAddressforcommunicationParameternamevOL A10B [Userdisplayselect]Min/MaxrangeDescriptionThis parameter displays the item selected atH73- [Monitoring item select].vOL Output voltageFactorydefaultsAdj.duringrunvOL - 9-21 X 8-240 X 8-24POr Output powertOr TorquenOn A10C [FaultDisplays the types of faults, frequency and - - 9-4Display]operating status at the time of the faultdrC A10D [Direction F, r Sets the direction of motor rotation when drv - F O 7-8of motor[Drive mode] is set to either 0 or 1.rotationF Forwardselect]r Reversedrv2 A10E [Drive 0 ~ 4mode 2]0 Run/Stop via Run/Stop key on the keypad4 Set to Filed Bus Communication 3)1Terminal FX: Motor forward runoperation RX: Motor reverse run2FX: Run/Stop enableRX: Reverse rotation select3 RS-485 communicationFrq2 1) A10F [Frequency 0 ~ 9 0 Digital Keypad setting 19 Set to Filed Bus Communication 3)setting1Keypad setting 2method 2]2 Analog V1 1: -10 ~ +10 [V]3 V1 2: 0 ~ +10 [V]4 Terminal I: 0 ~ 20 [mA]5Terminal V1 setting 1 +Terminal I6Terminal V1 setting 2+Terminal I7 RS485 communication8 Digital VolumerEF 2) A110 PID control 0~400 If H58 is 0, it is expressed as a [Hz] unit. 0.00 0 8-11standard [Hz] or If H58 is 1, it is expressed as a [%] unit.value 0~100 In [Hz] unit, you can’t set Max. frequencysetting [%] more than (F21).In [%] unit, 100% means Max. frequency.Fbk 2) A111 PID controlIt indicates a feedback amount in PID - - 8-11feedbackcontrol.amountIf H58 is 0, it is expressed as a [Hz] unit.If H58 is 1, it is expressed as a [%] unit.1) : Only displayed when one of the Multi-function input terminals 1-8 [I17~I24] is set to “22”.2) : It is indicated when H49(PID control selection) is 1.3) : This function can be available with iG5A Communication Option Module.Page5-2