iG5A, product manual - H2flow

CHAPTER 5 - FUNCTION LIST• Drive GroupLEDdisplayAddressforcommunicationParametername0.00 A100 [Frequencycommand]ACC A101 [Acceltime]dEC A102 [Deceltime]drv A103 [Drivemode]Frq A104 [Frequencysettingmethod]St1 A105 [Multi-Stepfrequency1]St2 A106 [Multi-Stepfrequency2]St3 A107 [Multi-Stepfrequency3]CUr A108 [Outputcurrent]rPM A109 [MotorRPM]dCL A10A [InverterDC linkvoltage]Min/Maxrange0 ~400[Hz]0 ~6000[Sec]0 ~ 40 ~ 90 ~400[Hz]DescriptionThis parameter sets the frequency that theinverter is commanded to output.During Stop: Frequency CommandDuring Run: Output FrequencyDuring Multi-step operation:Multi-step frequency 0.It cannot be set greater than F21- [Maxfrequency].During Multi-Accel/Decel operation, thisparameter serves as Accel/Decel time 0.FactorydefaultsAdj.duringrun0.00 O 7-1Page5.0 O 7-1210.0 O 7-120 X4 Set to Field Bus communication 1) -0 Run/Stop via Run/Stop key on the keypad 1 X 7-81FX: Motor forward run7-8Terminal RX: Motor reverse run2operation FX: Run/Stop enableRX: Reverse rotation select3 RS485 communication 7-90 Digital Keypad setting 1 7-19 Set to Field Bus communication 1) -1Keypad setting 2 7-12 V1 1: -10 ~ +10 [V] 7-23 V1 2: 0 ~ +10 [V] 7-34 Terminal I: 0 ~ 20 [mA] 7-45Analog Terminal V1 setting 1 +Terminal I7-56Terminal V1 setting 2+7-6Terminal I7 RS485 communication 7-58 Digital Volume 7-6Sets Multi-Step frequency 1 during Multi-step 10.00 O 7-7operation.Sets Multi-Step frequency 2 during Multi-stepoperation.Sets Multi-Step frequency 3 during Multi-stepoperation.20.00 O 7-730.00 O 7-7Displays the output current to the motor. - - 9-1Displays the number of Motor RPM. - - 9-1Displays DC link voltage inside the inverter. - - 9-11) : This function can be available with iG5A Communication Option Module.5-1