iG5A, product manual - H2flow

• Frequency setting via potentiometer & operating via the Run key1 -. Apply AC input power to the inverter.2 -. When 0.00 is displayed, press the Up () key three times.345678-. “drv” is displayed. Operating method is selectable.-. Press the Ent (•) key.-. Check the present operating method (“1”: Run via control terminal).-. Down () key once.-. After setting “0”, press the Ent (•) key. When 0 is blinking, press the Entagain.-. “drv” is displayed after “0” is blinking. Operation method is set via the Run keyon the keypad. -. Press the Up () key once.-. Different frequency setting method is selectable.-. Press the Ent (•) key.-. Check the present frequency setting method (“0” is run via keypad).-. Press the Up () key three times.9 -. After checking “3” (frequency setting via potentiometer), press the Ent (•) key.101112-. “Frq” is displayed after “3” is blinking. Frequency setting is set via thepotentiometer on the keypad.-. Press the Down () key four times.-. Turn the potentiometer to set to 10.0 Hz in either Max or Min direction.-. Press the Run key on the keypad.-. RUN lamp begins to blink with FWD lamp lit and accelerating frequency isdisplayed on the LED.-. When run frequency 10Hz is reached, 10.00 is displayed as shown left.-. Press the STOP/RST key.-. RUN lamp begins to blink and decelerating frequency is displayed on theLED.-. When run frequency is reached to 0Hz, Run and FWD lamp turn off and 10.00is displayed.RSTUVWMotor10 HzGVRV1CMKeypadFreq.Run keySTOP/RST keyNotes:WiringOperating pattern4-18