iG5A, product manual - H2flow

4.3 Moving to other groups• There are 4 different parameter groups in SV- iG5A series as shown below.Drive groupFU group 1FU group 2I/O groupDrive groupFunction group 1Function group 2I/O (Input/Output)groupBasic parameters necessary for the inverter to run. Parameterssuch as Target frequency, Accel/Decel time settable.Basic function parameters to adjust output frequency andvoltage.Advanced function parameters to set parameters for such asPID Operation and second motor operation.Parameters necessary to make up a sequence using Multifunctioninput/output terminal.• Moving to other parameter groups is only available in the first code of each group as thefigure shown below.Moving to other groups using the Right () Moving to other groups using the Left () keykey**Drive groupDrive groupI/O groupFunctiongroup 1I/O groupFunctiongroup 1Functiongroup 2Functiongroup 2* Target frequency can be set at 0.0 (the 1 st code of drive group). Even though the preset value is 0.0, it isuser-settable. The changed frequency will be displayed after it is changed.4-6