iG5A, product manual - H2flow

2.5 Control terminal specificationMO MG 24 P1 P2 CM P3 P4 S- S+3A 3B 3C P5 CM P6 P7 P8 VR V1 I AMWire size[mm 2 ]T/M Terminal Description singleStrandedwireScrewsizeP1~P8 Multi-function input T/M 1-8 1.0 1.5 M2.6 0.4CM Common Terminal 1.0 1.5 M2.6 0.4Torque[Nm]SpecificationVRV1IAMMOMGPower supply for externalpotentiometerInput terminal for VoltageoperationInput terminal for CurrentoperationMulti-function analog outputterminalMulti-function terminal foropen collectorGround terminal forexternal power supply1.0 1.5 M2.6 0.4 Output voltage: 12VMax output current:10mAPotentiometer:1 ~ 5kohm1.0 1.5 M2.6 0.4 Max input voltage:-10V ~ +10V input1.0 1.5 M2.6 0.4 0 ~ 20mA inputInternal resistor: 250ohm1.0 1.5 M2.6 0.4 Max output voltage: 11[V]Max output current:10mA1.0 1.5 M2.6 0.4 Below DC 26V,100mA1.0 1.5 M2.6 0.424 24V External Power Supply 1.0 1.5 M2.6 0.4 Max output current:100mA3A Multi-function relay output A 1.0 1.5 M2.6 0.4 Below AC 250V, 1Acontact3B Multi-function relay output 1.0 1.5 M2.6 0.4 Below DC 30V, 1AB contact3C Common for Multi-function 1.0 1.5 M2.6 0.4relaysNote 1) Tie the control wires more than 15cm away from the control terminals. Otherwise, it interferesfront cover reinstallation.Note 2) Use Copper wires rated 600V, 75 ℃ and higher.Note 3) Use the recommended tightening torque when securing terminal screws.NoteWhen you use external power supply (24V) for multi-function input terminal (P1~P8), terminals willbe active above 12V level. Take caution not to drop the voltage below 12V.2-12