iG5A, product manual - H2flow

Address Parameter Scale Unit Allotment for Bits0x320B15 ~ B8 : ReservedDigital input- - B7 : P8 B6 : P7 B5 : P6 B4 : P5InformationB3 : P4 B2 : P3 B1 : P2 B0 : P10x321Digital outputB15 ~ B2 : Reserved- -informationB1 : MOB0 : 3ABC0x0323 Select motor - - 0 : First motor, 1 : Second motor0x0324 V1 0.01 % Analog voltage input0x0325 I 0.01 % Analog current input0x0328 AO 0.01 % Analog outputB15 : Reserved B14 : OHT B13 : OC20x03300x03310x03320x0333Latch typetrip information-1Latch typetrip information-2Latch typetrip information-3H/W diagnosis tripinformation- -- -- -- -0x0334 Warning -B12 : EXT B11 : OVT B10 : OCTB9 : NTC B8 : Reserved B7 : ReservedB6 : COL B5 : POT B4 : GFTB3 : ETH B2 : IOLT B1 : ReservedB0 : OLTOthers : ReservedB3 : FANOthers : ReservedB2 : Lost commandB0 : BXOthers : ReservedB0 : HW-diagOthers : ReservedB4 : FAN workingB0 : OverloadB1 : LVTB2 : Inverter overload2.2) Inverter Control Area Parameters (Reading and Writing Available)Address Parameter Scale Unit Allotment for Bits0x0380Frequencycommand(Note1)0.01 Hz Command frequency setting0x0381RPMcommand(Note1)1 rpm Command RPM settingOthers : Reserved0x0382OperatingB3 : Free run stop (0->1) B2 : Trip reset (0->1)- -command(Note2)B1 : Reverse command (0), Forward command (1)B0 : Stop command (0), Run command (1)0x0383 Acceleration time 0.1 sec Acceleration time setting0x0384 Deceleration time 0.1 sec Deceleration time setting0x0388PIDreference(Note3)0.1 % PID reference command released0x0389PID feedbackvalue(Note4)0.1 % PID feedback valueNote 1) Writing available, when frequency command is communication.Note 2) Writing available, when run command is communication mode.Note 3) Writing available, when PID Reference (H57 = 4) is communication mode.Note 4) Writing available, PID Feedback(H50 = 2) is communication mode.11-10