iG5A, product manual - H2flow

4) Action Request for monitor register: Request for read of address registered by monitor register.ENQ Drive No CMD SUM EOT05h “01” ~ “1F” “Y” “XX” 04h1 byte 2 bytes 1 byte 2 bytes 1 byteTotal bite = 74.1) Acknowledge response:ACK Drive No CMD Data SUM EOT06h “01” ~ “1F” “Y” “XXXX…” “XX” 04h1 byte 2 bytes 1 byte n * 4 bytes 2 bytes 1 byteTotal bite= 7 + n * 4 = Max 394.2) Negative response:NAK Drive No CMD Error code SUM EOT15h “01” ~ “1F” “Y” “**” “XX” 04h1 byte 2 bytes 1 byte 2 bytes 2 bytes 1 byteTotal bite = 95) Error codeError code“IF”“IA”“ID”“WM”“FE”DescriptionWhen master is sending codes other than Function code (R, W, X, Y).When parameter address does not existWhen Data value exceeds its permissible range during ‘W’ (Write).When the specific parameters cannot be written during ‘W’ (Write).(For example, in the case of Read Only, Write disabled during Run)When frame size of specific function is not correct and Checksum field iswrong.11.7 Parameter code list (Note1): Area accessible regardless of inverter models (Note 2)Address Parameter Scale Unit R/W Allotment for Bits0x0000 Inverter model - - R A : iG5AFFFF :0.4kW0000 :0.75kW0003 :0004 :0x0001 Inverter capacity - - R2.2kW3.7kW0006 :0007 :5.5kW7.5kW0009 :000A :15kW18.5kW0002 :1.5kW0005 :4.0kW0008 :11kW000B :22kW11-6