iG5A, product manual - H2flow

• 12: During operation Activated when run command is input and inverter outputs its voltage.Freq.MORuncommand• 13: During stop Activated during stop without active command.Freq.MORuncommand• 14: during constant run Activated during constant speed operation.Freq.• 15: During speed searching Refer to page 8-17.MORuncommand• 16: Wait time for run signal input This function becomes active during normal operation and that the inverter waits foractive run command from external sequence.• 17: Fault output The parameter set in I56 is activated. For example, if setting I55, I56 to 17 and 2, respectively, Multi-function output relaywill become active when trip other than “Low voltage trip” occurred.• 18: Cooling fan trip alarm Used to output alarm signal when H78 is set to 0(constant operation at cooling fantrip). Refer to page 8-31.• 19: Brake signal It is used for signal output when set for use of external brake signal. Refer to the page8-26.9-11