iG5A, product manual - H2flow

Selects the self drive in the 2 nd switching of Frq2 among the followingsFrq2 Frequency mode 0 Keypad digital frequency mode1Digital21Keypad digital frequency mode22 V1 terminal setting1: -10 ~ +10V3 V1 terminal setting2: 0 ~ +10V4 Analog I terminal: 0 ~ 20mA5 V1 terminal setting1 + I terminal6V1 terminal setting2 + I terminal7 Setting via RS-485 communication8 Up-Down (Digital Volume) run9 Set to FieldBus communication The following is example for switching of drv1 and drv2.Group Display Parameter Name Setting Range Default UnitDrivegroupI/Ogroupdrv Drive mode 1 3 0 ~ 4 1 -Frq Frequency mode 1 0 0 ~ 9 0 -drv2 Drive mode 2 1 0 ~ 4 1Frq2 Frequency mode 2 0 0 ~ 9 0I24Multi-function inputterminal P8 input terminal22 0 ~ 27 7 The following figure is drawn when setting is like the above and command frequency is 30 [Hz],F4 [stop method]=01 Accelerate for accel time up to setting frequency by Drive 1 mode, FX signal.2 Drive continuously under FX is ON because DRV2 is 1 when P8 terminal input is ON andchange into 2 nd .3 Stop gradually as stop command because DRV is communication drive when P8 terminalinput is OFF and change into 1st.4 Accelerate up to setting frequency for Drive 1 mode, FX signal is ON.5 Stop gradually under FX is OFF because DRV2 is 1 when P8 terminal input is ON andchange into 2 nd .CAUTIONIf you press ON while multi-function input terminal (P1 ~ P8) is set to 2 nd Source,frequency command and drive command is changed to Drive mode 2. So youshould check Drive mode 2 before input multi-function terminal.8-23