DECLARATION OF PERFORMANCE

DECLARATION OF PERFORMANCEDoP No. 1020-CPD-090-0268601. Unique identification code of the product-type:Powers NHS Nylon Hammer-ScrewType, batch or serial number or any other element allowing identification of the construction product asrequired pursuant to Article 11(4):ETA-11/0483Batch number: see packaging of the product.Intended use or uses of the construction product, in accordance with the applicable harmonised technicalspecification, as foreseen by the manufacturer:generic typePlastic Nail-in anchor for fixing of external thermal insulation compositesystems, size 5 mm, 6 mm and 8 mmfor use in Uncracked and cracked concrete, C12/15 to C50/60 acc. to EN 206Masonry of solid clay bricks and calcium silicate bricks acc. to 771The anchor may be used multiple fixings for the anchorage of profiles forbonded thermal insulation composite systems (ETICS) according to ETAG 004.option / categoryloadingmaterialtemperature rangeETAG 014, categories A and BWind suction loads onlyPolyamide PA6, grade 2000, galvanized steel or stainless steel nailGalvanized steel nail: thermal insulation cover of at least 50 mmStainless steel nail: no restrictionscovered size: 5 mm, 6 mm and 8 mmNot applicable2. Name, registered trade name or registered trade mark and contact address of the manufacturer as requiredpursuant to Article 11(5):Product name: NHS-PROPowers Fasteners Europe B.V.Stanley Black & Decker Deutschland GmbHBlack-&-Decker Str. 4065510 IdsteinGermany3. Where applicable, name and contact address of the authorised representative whose mandate covers thetasks specified in Article 12(2): --4. System or systems of assessment and verification of constancy of performance of the construction productas set out in Annex V: System 2+5. In case of the declaration of performance concerning a construction product covered by a harmonisedstandard: --6. In case of the declaration of performance concerning a construction product for which a European TechnicalAssessment has been issued:TZUS TECHNICKÝ A ZKUŠEBNÍ ÚSTAV STAVEBNÍ Prague issued: ETA-11/0483on the basis of ETAG 014, categorioes A and BThe notified body 1020-CPD performed certification of factory production control on the basis of:- initial inspection of factory and of factory production control;- continuous surveillance, assessment and approval of factory production control.DoP No. 1020-CPD-090-026860 (R1) 1

9. Declared performance:EssentialCharacteristicscharacteristicresistancesminimum spacing andminimum edgedistancedisplacement forserviceability limitstateDesign MethodPerformanceETAG 014 ETA-11/0483, annex 4ETAG 014 ETA-11/0483, annex 3ETAG 014 Section 4.2.1.4HarmonizedTechnicalSpecificationETAG 014Where pursuant to Article 37 or 38 in the Specific Technical Documentation has been used, therequirements with which the product complies: --10. The performance of the product identified in points 1 and 2 is in conformity with the declared performance inpoint 9.This declaration of performance is issued under the sole responsibility of the manufacturer identified in point 4.Signed for and on behalf of the manufacturer by:_________________________Colin EarlVP HTF CDIY Europe___________________________Dr. Ing. Thilo PregartnerSenior Engineering ManagerDoP No. 1020-CPD-090-026860 (R1) 2