ISSN: 2250-3005 - ijcer

More documents

Recommendations

Info

International Journal Of Computational Engineering Research (ijceronline.com) Vol. 2 Issue. 8Simulator ParametersMac Type IEEE 802.11Protocols under studiedTransmission rangeNode movement modelTraffic typeAntennaNode SpeedPropagation modelChannel FrequencyNetwork ProtocolsAODV, DYMO, OLSRv2-Niigata, OLSR-Inria,RIPng600mRandom way point, 0-5m/s, pause time 0sCBROmni directional10m/s, 20m/s, 50m/s, 100m/sTwo Ray Ground2.4 GHzIPv6Scenario ParametersNumber of nodes 10 to 100Topology area1500x1500Packet size 512Item to send 100Simulation timeBattery Charge MonitoringIntervalFull Battery CapacityPerformance Matrices inApplication LayerPerformance Matrices inPhysical Layer30 Seconds60 Sec.1200 (mA,h)Average Jitter, End to End Delay, Throughput,Total Packet receivedEnergy consumed (in mjules) in transmit modeEnergy consumed (in mjules) in received modeEnergy Consumed (in mjules) in ideal modeEnergy model ParametersEnergy ModelEnergy Supply VoltageTransmit Circuitry PowerConsumptionMica motes6.5 Volt100.0 mW||Issn 2250-3005(online) || ||December|| 2012 Page 325
International Journal Of Computational Engineering Research (ijceronline.com) Vol. 2 Issue. 8Receive Circuitry PowerConsumptionIdle Circuitry PowerConsumptionSleep Circuitry PowerConsumption130.0 mW120.0 mW0.0 mWEnergy Model S pecificationsInitial Energy (Joules) 15Transmission Power (Watt) 1.4Receiving Power (Watt) 1.0Idle Power (Watt) 0.0Scenario designed for AODV, DYMO, OLSRv2-Niigata, OLSR-Inria, RIPng with Varying Network Size (10-100). Theparameters of Table 1 deployed in QualNet simulator assigned in 10-100 nodes sources are randomly distributed over a 1500mx 1500m area. The maximum speed varies from 1 to 21 m/s. Pause time is set at 5 sec. Consequently, most nodes move at alltimes.3.1. Snapshot of SimulationThe simulations of energy traffic model were performed using QualNet Simulator 5.0.1, the traffic sources are CBR(continuous bit rate). The source-destination pairs are multip lying randomly over the network. During the simulation, each nodestarts its journey from a source node to destination node. This process repeats throughout the simulation, causing continuouschanges in the topology of the underlying network. Fig.1 Shows the running simulation of snapshot when we applying CBR (1 -20) nodes and DYMO routing protocol.Figure1. Snapshot of QualNet Animator in action for applying DYMO protocol using 100 nodes.4. Results & Analysis4.1. Analysis and impact of Throughput (Bits/s):The throughput of the protocols can be defined as successful average rate of data packets received at its destinationamong the packets sent by the source. Throughput of all protocols decreases when the size of network increases. Thethroughput is measured in bits per second (bit/s or bps). For better system performance the number of bits per sec must be high.||Issn 2250-3005(online) || ||December|| 2012 Page 326
Page 1 and 2:
ISSN: 2250-3005VOLUME 2 December 20
Page 3 and 4:
Meisam MahdaviQualification: Phd El
Page 5 and 6:
16. Implementation Of Serial Commun
Page 7 and 8:
45 Performance Evaluation Of Energy
Page 9 and 10:
International Journal Of Computatio
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
01 .048International Journal Of Com
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
INTERNATIONAL JOURNAL OF COMPUTATIO
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Body Acceleration (m/Sec2)Dynamic T
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
Page 216 and 217:
Page 218 and 219:
Page 220 and 221:
Page 222 and 223:
Page 224 and 225:
EigenvalueEigenvalueInternational J
Page 226 and 227:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
Page 238 and 239:
Page 240 and 241:
Page 242 and 243:
Page 244 and 245:
Page 246 and 247:
Page 248 and 249:
Page 250 and 251:
Page 252 and 253:
Page 254 and 255:
Page 256 and 257:
Page 258 and 259:
Page 260 and 261:
Page 262 and 263:
Page 264 and 265:
Page 266 and 267:
Page 268 and 269:
Page 270 and 271:
Page 272 and 273:
Page 274 and 275:
Page 276 and 277:
Page 278 and 279:
Page 280 and 281:
Page 282 and 283: International Journal Of Computatio
Page 334 and 335: Average JitterThroughputInternation
Page 336 and 337: Energy Consumed in Received ModeEne
show all

ISSN: 2250-3005 - ijcer

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?