Eagle - Premier RC

4Insert UnderwingSpreader through thehole in zippered bodyand into the dihedral.6BungeeNockInsert the Underwing Spreader into the hole in the zipperd body.Make sure the dihedral is positioned correctly and insert theUnderwing Spreader into the dihedral. Zip up the body.Stretch the Wing Tension Bungee Loops over the Wing Tip Nocks.5Outer LeadingEdge Connector7IMPORTANT!Correct Tail PositionSlide Tail Spreaderthrough loops andinto pockets Loops PocketStand-offsIncorrect Tail PositionInsert remaining end of the Underwing Spreader into theOuter Leading Edge Connector. Connect both Stand-offs intothe Stand-off Connectors on the Underwing Spreader.Repeat 4 & 5 with second Underwing Spreader on other side.Flip the kite over. Slide the Tail Spreader under the loops at the middle ofthe tail. Insert the ends of the Tail Spreader into the pockets on each sideof the tail. Make sure the tail points upward. If necessary, rotatethe ferrule inside the spine sleeve until the tail points upward.6 7