Technical Service Manual - mbm-Service GmbH
Technical Service Manual - mbm-Service GmbH
Technical Service Manual - mbm-Service GmbH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
KIT CONTENTS<br />
• Shelf, 1 ea.<br />
• Shelf supports, 2 ea. (60" models<br />
offer 3 ea.)<br />
• 1/4-20x1" Hex Head Bolt, 4 ea.<br />
• 1/4-20x1-1/2" Hex Head Bolt, 4 ea.<br />
(60" models offer 6 ea.)<br />
• 1/4" Flat Washer, 4 ea. (60" models<br />
offer 6 ea.)<br />
REQUIRED TOOLS<br />
• 7/16 Wrench<br />
INSTALLATION<br />
INSTALLATION INSTRUCTION<br />
OVERSHELF OPTION - TSSU, TWT, TUC<br />
Congratulations on your purchase of an accessory that has been designed to efficiently assist your food<br />
preparation. The following instruction has been written to assist you in your overshelf installation.<br />
___________ STEP 1 ___________<br />
Place one flat washer on each of the<br />
1/4-20x 1-1/2" hex head bolts and<br />
insert one of these assemblies into each<br />
mounting hole, located on the longer<br />
section of the square shelf support.<br />
___________ STEP 2 ___________<br />
Hold the shelf support next to the<br />
threaded holes that are located along<br />
the edge on the back of the cabinet,<br />
(60" models have a third shelf support<br />
that is located near the center of the<br />
cabinet back).<br />
___________ STEP 3 ___________<br />
Carefully thread the 1/4-20 x 1-1/2"<br />
bolts into these threaded holes until the<br />
supports make contact with the cabinet<br />
and the bolts are hand tight.<br />
___________ STEP 4 ___________<br />
Repeat steps 2 and 3 to install the second<br />
shelf support, (for 60" models,<br />
repeat steps 2 and 3 for the third support).<br />
___________ STEP 5 ___________<br />
Hold the shelf up between the two<br />
mounted shelf supports and thread one<br />
1/4-20x1" hex head bolt into each of<br />
the two threaded holes that are located<br />
on the inside surface of each shelf support,<br />
(for the 48" and 60" models, have<br />
someone help hold the shelf in position).<br />
Thread each bolt until the shelf<br />
is drawn against the shelf support and<br />
the bolt is hand tight.<br />
81<br />
Figure 1.<br />
___________ STEP 6 ___________<br />
Adjust the shelf assembly so that the<br />
shelf supports are vertical and the shelf<br />
is flat<br />
___________ STEP 7 ___________<br />
Firmly tighten each bolt using the<br />
7/16 wrench.<br />
CAUTION<br />
Do not place more than 100 lbs.<br />
of weight upon the overshelf, and<br />
never stand on the overshelf.