Technical Service Manual - mbm-Service GmbH
Technical Service Manual - mbm-Service GmbH
Technical Service Manual - mbm-Service GmbH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
1. Disconnect power from cabinet.<br />
2. Remove door(s) by removing the screws securing upper hinge to the counter top, and pull top of door<br />
towards you.<br />
3. Locate & remove 2-2 3/4 inch screws in the black plastic trim in the top of each door or top drawer opening.<br />
4. Cut silicone seal with razor knife on inside and outside of cabinet, break the silicone seal on both sides<br />
and along the front edge with a putty knife.<br />
5. Lift top upward two-three inches and push backwards, this will unhook top from lip in rear edge of cabinet.<br />
6. To install top, apply a bead of black silicone to the top of the cabinet and, hook top on lip at rear of the<br />
cabinet and pull forward, press down firmly on the top and install screws through cabinet into top.<br />
7. Reinstall doors<br />
TOP REMOVAL FOR VARIOUS COOLERS<br />
TSSU,TWT,TUC<br />
To Install New Top<br />
1. Lay cabinet on its back & align doors with edge of cabinet. Pay attention to proper spacing of door along<br />
edge, it should be approximately 5/8". Place new silicone beads inside & out.<br />
2. When installing a new top use 5/8" spacers at outer edge of the door and cabinet to locate door properly.<br />
3. Push mounting plate on<br />
KEIL hinge until parallel<br />
with front of cabinet and<br />
mark center of hinge holes.<br />
Drill holes with #7 drill bit<br />
or .201 Dia. Install door on<br />
cabinet with black plastic<br />
spacer between hinge<br />
bracket and counter top<br />
and run screws into new<br />
holes and remove spacer<br />
blocks.<br />
Top<br />
Evaporator Housing<br />
32<br />
Top Screws
Change language