Cisco WAP200 Wireless-G Access Point with PoE and ...

More documents

Recommendations

Info

Wireless-G Access Point with Power Over Ethernet and RangeboosterThe PortsThe Access Point’s port are located on the back of the device.port: the connection point on a computer ornetworking device used for plugging incables or adaptersFigure 3-2: Back ViewReset ButtonEthernetPowerThere are two ways to reset the Access Point to the factory default configuration. Either pressthe Reset button, for approximately ten seconds, or restore the defaults using the AccessPoint's web-based utility.The Ethernet network port connects to Ethernet network devices, such as a switch or routerthat may or may not support Power over Ethernet (PoE).The Power port connects to the supplied power adapter.IMPORTANT: Resetting the Access Point willerase all of your settings (including wirelesssecurity, IP address, and SSID) and replacethem with the factory defaults. Do not resetthe Access Point if you want to retain thesesettings.Chapter 3: Getting to Know the Wireless-G Access PointThe Ports8
Wireless-G Access Point with Power Over Ethernet and RangeboosterAntennas and PositionsThe Access Point’s antennas are located on the back of the device. The Access Point can be placed on a desktopor wall-mounted. When placed on a desktop, the Access Point can be stacked with other Linksys Business Seriesproducts.AntennaThe Access Point has two detachable 2dBi omni-directional antennas. Adjust the two antennasso that they form a 90 degree angle for best MIMO range performance.Figure 3-3: Desktop Placement and Antenna SetupChapter 3: Getting to Know the Wireless-G Access PointAntennas and Positions9
Page 1 and 2: Wireless-G Access Pointwith Power O
Page 3 and 4: Wireless-G Access Point with Power
Page 13: Wireless-G Access Point with Power
Page 65 and 66:
Wireless-G Access Point with Power
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
show all

Cisco WAP200 Wireless-G Access Point with PoE and ...

Create successful ePaper yourself

Delete template?

Save as template?