CSI 2140 Machinery Health Analyzer - Emerson Process Management

CSI 2140 Machinery Health Analyzer June 2013Input specificationsInput signalsFull scale input levelAccel Channels A, B, C, D; Volts A, B, C, DAccelerometer Input 0-20VVolts Input -20V to +20VA 2-milliampere, 20-volt (nominal), constant-current power supply inside the analyzerpowers sensors such as accelerometers connected to the accelerometer channel inputs.Full scale vibration level is +/- 90 g’s when using a 100-mV/g accelerometerInput ImpedanceGreater than 125K ohmsInput signal typesDynamic signalsDC signalsRPM/tach signalKeypad entrySingle channel/Dual channel/Four channelSingle channel/Dual channel/Four channelTTL pulseFull alphanumeric capabilityFour-Channel Data CollectionSimultaneous 4-channels Dynamic Input + PhaseSimultaneous 4-channels DC InputSimultaneous 4-channel Route collection + PhaseSimultaneous 4-channel Display - Spectrum and WaveformSimultaneous 4-channel Transient + PhaseSimultaneous 4-channel ODS/Modal + PhaseSimultaneous 4-channel Volt/Displacement + Phase (for sleeve bearing monitoring)Simultaneous Dual Orbits Display [accelerometer/displacement] (for rolling element/sleeve bearing monitoring)Simultaneous 4-channel Cross Channel + PhaseIn-field Route Analysis ToolsFault frequency overlays on plotParameter trendsColored alarmsWaveform autocorrelationInput sensor typesPortable sensorsInstalled sensorsIdentifies source of vibration peaksUp to 12 parameters trended over 2+ yearsShows specific parameter in alarm and percentage of alarm valueIdentifies whether impacting is periodic or randomAccelerometers, velocity probes, RPM/tachometer probes, temperature sensors, flux coil,current clamp, pressure sensors, triaxial accelerometer, impact hammerAny vibration or dynamic sensor with a voltage output; any DC-type signal.10www.assetweb.com