Fastrax Product Leaflet

Fastrax Product Leaflet Fastrax Product Leaflet

11.07.2015 Views

GPS RECEIVER MODULESModule IT600 IT500 IT520 IT430General L1 frequency (GPS, Glonass Galileo) L1 frequency, C/A code (SPS)Channels 32 22 track + 66 acq. 22 track + 66 acq. 48Update rate up to 10 Hz up to 10 Hz up to 10 Hz 1 HzAccuracyPosition 2.7 m (CEP 95) 2.7 m (CEP 95) 2.7 m (CEP 95) 2.5 m (CEP 50)Velocity < 0.1m/s 0.1m/s 0.1m/s 0.01m/sTime 15ns RMS 50ns RMS 50ns RMS 1us (typ.)Time-to-first-fix (TTFF), typicallyCold start 33s 33s 33s 35sWarm start 33s 33s 33s 35sHot start 1s 1s 1s 1sSensitivityAcquisition (cold start) -146 dBm -148 dBm -148 dBm -147 dBmRe-acquisition -150 dBm -160 dBm -160 dBm -162 dBmNavigating -162 dBm (tracking) -165 dBm -165 dBm -163 dBm (tracking)Power drainNavigating 150-230 mW typ. 75mW typ. 75mW typ. 56/68mWBackup state 50uW 15uW 15uW 36uW (hibernate)Operating voltageMain supply +1.8V +3.0V...4.2V +3.0V...4.2V +1.8VBackup supply +1.62V...3.6V +2.0V...4.2V +2.0V...4.2V --Protocol NMEA 0183 NMEA 0183 NMEA 0183 NMEA 0183, OSP binaryBaud rate 115200 (configurable) 9600 (configurable) 9600 (configurable) 4800 (configurable)Chipset ST Teseo II Mediatek MTK3329 Mediatek MTK3329 SiRFstar IV (GSD4e)Dimensions 16.2 x 18.8 x 2.3 mm 16.2 x 18.8 x 2.3 mm 10.4 x 14.0 x 2.3 mm 9.6 x 9.6 x 1.85 mmWeight 3.0 g 1.5 g 0.7 g 0.4 gOperating temperature -40C...+85C (1) -40C...+85C -40C...+85C -40C...+85C (1)Storage temperature -40C...+85C -40C...+85C -40C...+85C -40C...+85CHW optionsMemory size 16MBit 4 MBit 4 MBitAntenna External, passive or active External, passive or active External, passive or active External, passive or activeAntenna input LGA pad, 50 ohm LGA pad, 50 ohm LGA pad, 50 ohm LGA pad, 50 ohmAntenna bias Same as I/O supply VDD3V3 Same as VDD Same as VDD Antenna bias supply inputI/O ports36 contact castellated viasThree asynchronous serial ports1PPS outputI2C or CAN1CAN0JTAGADC input for Analog Gyro from carOdometer input from carRSTn, STANDBYn, WAKEUP inputsSPI Interface30 contact LGATwo asyncronous serial ports1PPS outputAntenna detector status pins24 contact LGATwo asyncronous serial ports1PPS outputAntenna detector status pins28 contact LGAOne host port: UART, SPI or I2COn_OFF control input1PPS outputAntenna bias supply inputDedicated I2C port forexternal sensors(1) Operates down to -40degC, all specifications are not guaranteed below -30degC30 www.fastraxgps.comThe specifications in this document are subject to change without prior notice. Fastrax makes no warranties, either expressed or impliedwith respect to the information and specifications contained in this document. Performance characteristics listed in this document areestimates based on currently available firmware and do not constitute a warranty or guarantee of product performance.

SPECIFICATIONSOEM GPS ReceiversGPS ANTENNA MODULESIT03 UP501 UP300 UC43012 22 track + 66 acq. 20 48up to 3 Hz up to 10 Hz 1 Hz 1 Hz2.7 m (CEP 95) 2.7 m (CEP 95) 2.7 m (CEP 95) 2.5 m (CEP 50)0.1m/s 0.1m/s 0.1m/s 0.01m/s20ns RMS 50ns RMS 1us 1us (typ.)35s 33s 32s 35s34s 33s 32s 35s4s 1s 1s 1s-142 dBm -148 dBm -146 dBm -147 dBm-149 dBm -160 dBm -157 dBm -162 dBm-156 dBm -165 dBm -159 dBm -163 dBm (tracking)95mW typ. 75mW typ. 84mW typ. 68mW20uW (sleep mode) 15uW 18 uW typ. 36uW (hibernate)+2.7V..3.3V +3.0V...4.2V +3.0V..3.6V +1.8V- +2.0V...4.2V +1.5V..3.6V --NMEA, iTalk NMEA 0183 NMEA, Sirf binary NMEA 0183, OSP binary4800 (configurable) 9600 (configurable) 9600 (configurable) 4800 (configurable)uN2110 + uN8021 Mediatek MTK3329 SiRFstar III (GSC3f/LPx) SiRFstar IV (GSD4e)21.6 x 23.3 x 2.6 mm 22.0 x22.0 x 8.0 mm 19.0 x 27.0 x 7.2 mm 9.6 x 14.0 x 1.95 mm2.7 g 9.0 g 9.1 g 0.5 g-40C...+85C -40C...+85C -40C...+85C (1) -40C...+85C (1)-40C...+85C -40C...+85C -40C...+85C -40C...+85CIT0302 (replacement for IT02) UP501B (internal backup battery)UP501D (Dual SAW filter)16MBit 4 MBit 4 MBitExternal, passive or active Integrated patch 18.4 x 18.4 mm Integrated patch 18.4 x 18.4 mm,connector & switch for external ant.Embedded chip antenna(ground plane required)LGA pad, 50 ohm - Hirose U.FL-R, 50 ohm LGA pad, 50 ohmSame as VDDRF - Same as VDD37 contact LGATwo asynchronous serial ports22-pin GPIO (Shared functionality)2 x SPI-interfaceDual pulse measurement inputs1PPS output2 x Pulse measurement timers2 x Capture timers2 x Clock inputsMMC (Master) connection6 contact pin solderingTwo asynchronous serial portsMain & Back-up supply1PPS output8-pin cable connectorOne asynchronous serial portMain & Back-up supply1PPS outputRESET inputUPDATE input (re-programming)31 contact LGAOne host port: UART, SPI or I2COn_OFF control input1PPS outputAntenna output, RF inputDedicated I2C port for external sensorssmartpositioning11/201131

SPECIFICATIONSOEM GPS ReceiversGPS ANTENNA MODULESIT03 UP501 UP300 UC43012 22 track + 66 acq. 20 48up to 3 Hz up to 10 Hz 1 Hz 1 Hz2.7 m (CEP 95) 2.7 m (CEP 95) 2.7 m (CEP 95) 2.5 m (CEP 50)0.1m/s 0.1m/s 0.1m/s 0.01m/s20ns RMS 50ns RMS 1us 1us (typ.)35s 33s 32s 35s34s 33s 32s 35s4s 1s 1s 1s-142 dBm -148 dBm -146 dBm -147 dBm-149 dBm -160 dBm -157 dBm -162 dBm-156 dBm -165 dBm -159 dBm -163 dBm (tracking)95mW typ. 75mW typ. 84mW typ. 68mW20uW (sleep mode) 15uW 18 uW typ. 36uW (hibernate)+2.7V..3.3V +3.0V...4.2V +3.0V..3.6V +1.8V- +2.0V...4.2V +1.5V..3.6V --NMEA, iTalk NMEA 0183 NMEA, Sirf binary NMEA 0183, OSP binary4800 (configurable) 9600 (configurable) 9600 (configurable) 4800 (configurable)uN2110 + uN8021 Mediatek MTK3329 SiRFstar III (GSC3f/LPx) SiRFstar IV (GSD4e)21.6 x 23.3 x 2.6 mm 22.0 x22.0 x 8.0 mm 19.0 x 27.0 x 7.2 mm 9.6 x 14.0 x 1.95 mm2.7 g 9.0 g 9.1 g 0.5 g-40C...+85C -40C...+85C -40C...+85C (1) -40C...+85C (1)-40C...+85C -40C...+85C -40C...+85C -40C...+85CIT0302 (replacement for IT02) UP501B (internal backup battery)UP501D (Dual SAW filter)16MBit 4 MBit 4 MBitExternal, passive or active Integrated patch 18.4 x 18.4 mm Integrated patch 18.4 x 18.4 mm,connector & switch for external ant.Embedded chip antenna(ground plane required)LGA pad, 50 ohm - Hirose U.FL-R, 50 ohm LGA pad, 50 ohmSame as VDDRF - Same as VDD37 contact LGATwo asynchronous serial ports22-pin GPIO (Shared functionality)2 x SPI-interfaceDual pulse measurement inputs1PPS output2 x Pulse measurement timers2 x Capture timers2 x Clock inputsMMC (Master) connection6 contact pin solderingTwo asynchronous serial portsMain & Back-up supply1PPS output8-pin cable connectorOne asynchronous serial portMain & Back-up supply1PPS outputRESET inputUPDATE input (re-programming)31 contact LGAOne host port: UART, SPI or I2COn_OFF control input1PPS outputAntenna output, RF inputDedicated I2C port for external sensorssmartpositioning11/201131

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!