Stow Davis Specification Guide - OEC Business Interiors

LandmarkProduct DetailsABCSolid wood worksurfacenosings are availablewith three edge profiles—A, B, or C. A variety ofother edge profiles areavailable as specials.Edge profile locationvaries by component.Visitor’s sideArcUser’s sideStraightDesk worksurfaceshave the specified edgeprofile on the user’s sideand visitor’s side, with asquare edge band on theremaining sides.IntegralUser’s sideCredenza worksurfaceshave specified edgeprofile on the user’s sideonly, with a square edgeband on the remainingsides...User’s sideReturn worksurfaceshave the specified edgeprofile on the user’s side, areverse edge profile on theattachment side, and asquare edge band on theremaining sides.User’s sideBridge worksurfaceshave the specified edgeprofile on the user’s side, areverse edge profile on thetwo attachment sides, and asquare edge band on theremaining side.Drawer and door pullsare available in threeshapes—arc, straight, andintegral. Arc and straightpulls use the same hole patternto allow a wide varietyof options as specials..8"7 1 /4"8"12 3 /4"Visitor’s SideVisitor’s SideVisitor’s SideRecessedOffsetNotched.Modesty panels ondouble-pedestal deskscan be specified in three differentversions—recessed,offset, and notched. Overhangon the visitor’s sideof the worksurface is 8" forrecessed modesty panel,7 1 ⁄4" for offset modestypanel, and 8" for notchedmodesty panel. Notchedmodesty panel is inset anadditional 4 3 ⁄4" for an overhangtotal of 12 3 ⁄4".Bullet-shape desks andrun-off tables provide aconferencing area. Bulletshapedesks are freestanding.Bullet-shape run-offtables must be attached toa credenza.Credenzas and returnsare specified as modularbuildups. Worksurfaces arespecified separately frommodular storage and endpanelcomponents. Piecescan be configured to thedesired functionality andaesthetic upon installationand can be reconfigured inthe future.Pedestals are availableas buildups for use with credenzasand returns and arealso available freestandingas lateral files.Finished back panelsare specified separately in arange of dimensions from18"W to 120"W. They canbe used to finish off an individualpedestal (when theback of that pedestal will bevisible) or to span severalpedestals, end panels, andkneespace within a credenza,bridge, or return.7 /8"Pedestal and towerbases are 7 ⁄8"H solid particleboard with veneer edgebanding. Bases have acutout in the center to allowwire routing.Pedestal backs areunfinished and are open toallow access to wall outlets.Finished back panels canbe specified and attachedin the field if back will bevisible.Tip: Freestanding lateralfiles have finished backs.21"24"3 /4" 2 3 /4"20" 20"20"D pedestals shouldbe used with 21"D credenzaand return worksurfaces.20"D pedestal should alsobe used with 24"D credenzaand return worksurfaceswhen more room is neededfor routing wires.3 /4"Without With FlushBack Panel Back Panel23"D pedestals shouldbe used with 24"D credenzaand return worksurfacesonly. When installed, theworksurface should overhangthe back of thepedestal by 3 ⁄4" when backis unfinished. When installedwith a finished back panel,the back edge of the worksurfaceshould be flush with. the finished back panel. .BackBackLandmarkStow Davis Specification Guide cLandmark, continued 97