Stow Davis Specification Guide - OEC Business Interiors

The Richard Meier Collection, continued.Overhead shelf is availableon workwall to provideadditional open storage ordisplay area and extend theheight of the unit.Stationery boxes areincluded inside workwallswith secretary. Solid woodboxes are removable andfeature mitered constructionand a felt underside.Chairs, sofas, andbenches are available toextend the aesthetic of theCollection to seatingelements. Sofa and chaircombinations—side-by-side,back-to-back, and at rightangles—are possible for awide range of applications.All chairs and sofas are availablein left- and right-handversions as determined bythe position of the smallestsupport leg. Cushions arebutton-tufted leather withmatching bolsters. Seatheight is 16 3 ⁄4"H..Wiring and CablingGrommets are integratedinto the large inlays in thesurface of wood-top desks,runoffs, and credenzas.Desks with glass tops donot include grommets.Grommets in workwalls arelocated in inlaid plate atrear of worksurface.Grommets are 1 1 ⁄2"W x 5 ⁄8"D.CableTrayCableChannelCable routing is possiblein concealed verticalchannels in the legs ofdesks and returns beneathgrommets. Removablecover allows lay-in cablerouting in 5 ⁄8"D x 1 1 ⁄2"Wchannel.Horizontal cable managementtray is includedto route wires and cablesbetween the grommetsbeneath the worksurface ofa desk or credenza.Removable kneespacepanel in workwalls allowswire routing out to the floor.Kneespace and back panelare open to the floor..Workwalls include cablerouting space between thetackboard and the backpanel.Low-voltage halogentask lights with built-intransformers and 8' powercords illuminate workwallworksurfaces..Surface MaterialsVeneer selection andmatching bring beautyand consistency to everypiece you order. Veneersare quarter-cut and bookmatchedto achieve a uniform,straight-grainedappearance. Individualveneer leaves are trimmedto fit the width of each panelfor a balanced match.Veneer for the entire pieceis cut from the same flitch.Veneer is applied to bothsides to control warpage.Grain direction is parallelto the long dimension onhorizontal surfaces, andruns vertically on all verticalsurfaces.Top surfaces are 45-degree gloss matte. Whenrequired, grain is filled.Drawer heads arematched in the selectedveneer. Solid maple front,back, and sides; mapleveneer bottom.Casegoods• Quarter-cut maple veneerwith Amber Maple stainLegs and supports• Quarter-cut maple veneerwith black paintGlass top• 3 ⁄4"-thick, clear, temperedglass with polished edgesand etched and sealedundersideTackboards• Vertical surface fabricprice groups 1, 2, 3, 4, 5,and COMSeating upholstery• Black leather (RS4999Tulsa Black from Brayton)Lock• 9250 Ember ChromeApplication TopicsA-series and B-seriespedestals are intended tobe installed flush with thefront edge of the worksurface.Proper placementensures that the lock in thekneewell will not be blockedby legs. Pulls on pedestalwill extend 3 ⁄4" beyond theworksurface.LeftRightPosition of small legdetermines if the desk,return, credenza, or seatingis left- or right-handed.AccentLeftAccentRightPosition of black verticalaccent determinesif workwall is left- or righthanded...380 Stow Davis Specification Guide