Stow Davis Specification Guide - OEC Business Interiors

Translations Open-Office Components, continued.ConnectionsAll connections betweencomponents are concealed.Furniture can be disassembled,reconfigured, andreassembled without anyvisible connection points.Partition wallCorner unitEnd unitIntermediate unitOpen-office configurationsstart with an openofficeend unit. The openofficeend unit connects toeither an open-office intermediateunit when a largerwork area is desired, or anopen-office corner unitwhen a smaller work areais desired. The open-officecorner unit then connectsto an open-office partitionwall. These componentsform the front of an openofficeconfiguration.Wiring & CablingCable passage zoneVisual symmetry is createdand maintained acrossOpen-office bridgesthe front of the open-officeconnect along one sideconfiguration by combiningedge to open-office cornerthe appropriate sizes ofunits, along one side edgeCable passage zonecomponents. Vertical, metal to open-office back units,in the back top edge ofaccent bars between the and along the back edge topedestals and support pan-components reinforce the open-office partition walls.els facilitates unobstructedvisual rhythm.The corresponding partitioncable routing throughcPage 260wall width must be used:multiple components.Open-office Open-officebridge partitionCable manager can bewallfield-installed beneath the36"W 69 13 ⁄16"Wworksurface of any unit to42"W 75 13 ⁄16"Wconceal wires and cables.48"W 81 13 ⁄16"WCable manager is included54"W 87 13 ⁄16"Wwith open-office end units,open-office intermediateWorkcenter units cannotunits, open-office cornerphysically attach to open-units, open-office returnoffice return shells or open-shells, open-office bridges,office bridges.open-office back units, andworkcenter units.Privacy panels connectto and can be removed fromopen-office intermediateunits and open-office cornerunits. Tools are required.20%Pedestals connect to theunderside of worksurfaces.Internode componentsPedestal width must be lessare available to extend powerthan the width of the corre-networks inside an individ-Open-office returnsponding shell. To deterualworkspace. Internodeshells connect along themine the space availablepowerblocks attach beneathside edge to open-officefor pedestals, deduct 3"worksurfaces via mountingcorner units, and along thefrom the width of the work-brackets. A wide variety ofback edge to open-officesurface.power harnesses is avail-partition walls. The correableto make connections.sponding partition wall widthComponents to form voicemust be used:and data networks areOpen-office Open-officealso available. Internodereturn shell partitioncomponents are orderedwallseparately.cPage 25736"W 69 13 ⁄16"W42"W 75 13 ⁄16"W48"W 81 13 ⁄16"W54"W 87 13 ⁄16"WShortened workwallend panels should beused when a tower or workcenterunit is placed next to.. an open-office back unit. .A B B B A.2 1 ⁄2"-round worksurfacegrommets allowcables to pass throughworksurfaces. Multiple locationoptions are available.cPage 254Access doors withpower and communicationsare 10"W metaldoors that provide power,voice, and data outlets atworksurface level. Theyinclude an Internodeconvenience tri-receptaclewith power cord and plugand convenience communicationoutlet housing.Multiple location optionsare available.cPage 255.252 Stow Davis Specification Guide