THREE-COAT STUCCO SYSTEM Section 09200 SECTION 09200 ...

17 ENVIRONMENTAL REQUIREMENTSA. Store materials for one day prior to installation in area of installation to achieve temperaturestability.1.1 MATERIALS - CARPETA. Carpet, is to be low pile, of a neutral color, and commercial grade.B. Samples must be submitted to owner prior to installation.1.2 MATERIALS-CUSHIONA. Cushion, is to be 3/8" foam rubber.B. Samples must be submitted to owner prior to installation.1.8 ACCESSORIESA. Sub-Floor Filler: White premix latex; type recommended by flooring material manufacturer.B. Edge Strips: (As Required)C. Base Gripper: (As Required)D. Adhesive: Recommended by cushion manufacturer and meet IBC 2009 requirements.PART 2 EXECUTION2.1 EXAMINATIONA. Verify that surfaces are smooth and flat with maximum variation of (1/4) inch in 10 ft andare ready to receive work.2.2 PREPARATIONA. Remove floor ridges and bumps. Fill minor or local low spots, cracks, joints, holes, andother defects with floor filler.B. Apply, trowel, and float filler to achieve smooth, flat, hard surface. Prohibit traffic until filleris cured.C. Vacuum clean substrate.2.3 INSTALLATION - CUSHIONA. Install in accordance with manufacturer's instructions.B. Install cushion using one piece for entire room,