acknowledgements for ansi/nist-itl 1-2011 - NIST Visual Image ...

More documents

Recommendations

Info

ANSI/NIST-ITL 1-2011 - UPDATE 2013 DRAFT VERSIONperson identification via two facial images or image and skull. They also allow specificationof points that are in use by criminal experts and anthropologists. Figure 15 123 and Table 66show the definition of the anthropometric landmarks. The set of points represents thecraniofacial landmark points of the head and face. The latter are used in forensics for “Faceto face” and “Skull to face” identification. In Field 10.029: 2D facial feature points / FFPand Field 10.032: 3D facial feature points/ 3DF, the FPT information item is coded witha value of “2”. Some of these points have MPEG 4 counterparts, others not. The error of ananthropometric 3D landmark point location should be no greater than 3mm. The point onthe surface is a vertex, or a point on an edge, or a point on a face of the surface.[2013e] The locations of points ZY and FT have been corrected in the profile view inFigure 15: Anthropometric facial landmarks defined in ISO/IEC 19794-5 [
ANSI/NIST-ITL 1-2011 - UPDATE 2013 DRAFT VERSIONTable 66 ISO definitions of the anthropometric landmarksFeaturePoint IDMPEG4FeaturePointAnthropometric PointNameDescriptionv 11.4 vertexThe highest point of head when the head is oriented inFrankfurt Horizon.g glabella The most prominent middle point between the eyebrowsopeuftopisthocranioneurionfrontotemporaleSituated in the occipital region of the head is most distantfrom the glabellaThe most prominent lateral point on each side of the skull inthe area of the parietal and temporal bonesThe point on each side of the forehead, laterally from theelevation of the linea temporalistr 11.1 trichion The point on the hairline in the midline of the foreheadzy zygion The most lateral point of each of the zygomatic bonesgosl2.152.16gonionsublabialepg 2.10 pogoniongn 2.1 menton (or gnathion)The most lateral point on the mandibural angle close to thebony gonionDetermines the lower border of the lower lip or the upperborder of the chinThe most anterior midpoint of the chin, located on the skinsurface in the front of the identical bony landmark of themandibleThe lowest median landmark on the lower border of themandiblecdlcondylion lateraleThe most lateral point on the surface of the condyle of themandibleen3.113.8endocanthionThe point at the inner commissure of the eye fissureex3.73.12exocanthion (orectocanthion)The point at the outer commissure of the eye fissurep3.53.6center point of pupilIs determined when the head is in the rest position and the eyeis looking straight forwardor3.93.10orbitaleThe lowest point on the lower margin of each orbitps3.13.2palpebrale superiusThe highest point in the mid-portion of the free margin ofeach upper eyelid214
Page 1:
NIST Special Publication 500-xxxANS
Page 5 and 6:
5.3.18 Type-18 records ............
Page 7 and 8:
8.1.4 Field 1.004 Type of transacti
Page 9 and 10:
8.9.7.18 Field 9.322: EFS core delt
Page 11 and 12:
8.11 Record Type-11: Forensic and i
Page 13 and 14:
8.14.2 Field 14.002: Information de
Page 15 and 16:
8.17 Record Type-17: Iris image rec
Page 17 and 18:
8.19.24 Field 19.902: Annotation in
Page 19:
8.24.6 Field 99.101: Biometric type
Page 22 and 23:
F.6.3 Reference points.............
Page 24 and 25:
Figure 34: Palm with carpal delta a
Page 26 and 27:
Table 31 Off-center fingerprint pos
Page 28 and 29:
Table 95 DNA sample cellular types.
Page 30 and 31:
Type-11:A new record type introduce
Page 32 and 33:
ACKNOWLEDGEMENTS FOR ANSI/NIST-ITL
Page 34 and 35:
Will Graves, Rob Mungovan, Catherin
Page 36 and 37:
John ManzoFBI/BIOMETRICS Center ofE
Page 38 and 39:
General Editor: Brad Wing[2013a>]AC
Page 40 and 41:
CANVASSEES For the 2013 UpdateTO BE
Page 42 and 43:
ANSI/NIST-ITL 1-2011 - UPDATE 2013
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205: ANSI/NIST-ITL 1-2011 - UPDATE 2013
Page 304 and 305:
Page 306 and 307:
Page 308 and 309:
Page 310 and 311:
Page 312 and 313:
Page 314 and 315:
Page 316 and 317:
Page 318 and 319:
Page 320 and 321:
Page 322 and 323:
Page 324 and 325:
Page 326 and 327:
Page 328 and 329:
Page 330 and 331:
Page 332 and 333:
Page 334 and 335:
Page 336 and 337:
Page 338 and 339:
Page 340 and 341:
Page 342 and 343:
Page 344 and 345:
Page 346 and 347:
Page 348 and 349:
Page 350 and 351:
Page 352 and 353:
Page 354 and 355:
Page 356 and 357:
Page 358 and 359:
Page 360 and 361:
Page 362 and 363:
Page 364 and 365:
Page 366 and 367:
Page 368 and 369:
Page 370 and 371:
Page 372 and 373:
Page 374 and 375:
Page 376 and 377:
Page 378 and 379:
Page 380 and 381:
Page 382 and 383:
Page 384 and 385:
Page 386 and 387:
Page 388 and 389:
Page 390 and 391:
Page 392 and 393:
Page 394 and 395:
Page 396 and 397:
Page 398 and 399:
Page 400 and 401:
Page 402 and 403:
Page 404 and 405:
Page 406 and 407:
Page 408 and 409:
Page 410 and 411:
Page 412 and 413:
Page 414 and 415:
Page 416 and 417:
Page 418 and 419:
Page 420 and 421:
Page 422 and 423:
Page 424 and 425:
Page 426 and 427:
Page 428 and 429:
Page 430 and 431:
Page 432 and 433:
Page 434 and 435:
Page 436 and 437:
Page 438 and 439:
Page 440 and 441:
Page 442 and 443:
Page 444 and 445:
Page 446 and 447:
Page 448 and 449:
Page 450 and 451:
Page 452 and 453:
Page 454 and 455:
Page 456 and 457:
Page 458 and 459:
Page 460 and 461:
Page 462 and 463:
Page 464 and 465:
Page 466 and 467:
Page 468 and 469:
Page 470 and 471:
Page 472 and 473:
Page 474 and 475:
Page 476 and 477:
Page 478 and 479:
Page 480 and 481:
Page 483 and 484:
Page 485 and 486:
Page 487 and 488:
Page 489 and 490:
Page 491 and 492:
Page 493 and 494:
Page 495 and 496:
Page 497 and 498:
Page 499 and 500:
Page 501 and 502:
Page 503 and 504:
Page 505 and 506:
Page 507 and 508:
Page 509 and 510:
Page 511 and 512:
Page 513 and 514:
Page 515 and 516:
Page 517 and 518:
Page 519 and 520:
Page 521 and 522:
Page 523 and 524:
Page 525 and 526:
Page 527 and 528:
Page 529 and 530:
Page 531 and 532:
Page 533 and 534:
Page 535 and 536:
Page 537 and 538:
Page 539 and 540:
Page 541 and 542:
Page 543 and 544:
Page 545 and 546:
Page 547 and 548:
Page 549 and 550:
Page 551 and 552:
Page 553 and 554:
Page 555 and 556:
Page 557 and 558:
Page 559 and 560:
Page 561 and 562:
Page 563 and 564:
Page 565 and 566:
Page 567 and 568:
Page 569 and 570:
Page 571 and 572:
Page 573 and 574:
Page 575 and 576:
Page 577 and 578:
Page 579 and 580:
Page 581 and 582:
Page 583 and 584:
Page 585 and 586:
Page 587 and 588:
Page 589 and 590:
Page 591 and 592:
Page 593 and 594:
Page 595 and 596:
Page 597:
show all

acknowledgements for ansi/nist-itl 1-2011 - NIST Visual Image ...

Create successful ePaper yourself

Delete template?

Save as template?