Floor Lite.pdf - Light Ideas International Ltd

Floor LiteCat. No. FLCat. No. FLFL3mm1 8”25mm1”3½”88mm68.5mm2¾”3”76mm1”148mm57 8 ”2563.5mm2½”100mm4”Floor Canister(Supplied with Luminaire)The Floor Lite has an extremely low profile (3mm) and can bewalked upon without damaging the luminaire. There are five flangedesigns: Clover, Grill, Louvre (45 degree angle), Spot, Cross and issupplied with a mounting canister.A 110/240 volt fluorescent option is available which offers excellentlight output, low energy usage and very low heat generation, thischanges the luminaire to an IP66 rating.3mm1 8”88mm3½”130mm5”25mm1” 63.5mm2½”Fluorescent Option1”2580mm13 8”210mm8¼”1Fluorescent Canister (PVC)(Supplied with Luminaire)Ordering InformationLuminaire TypeFL - Floor LiteFlangeCL - Clover (A)CR - Cross (B)GR - Grill (C)LU - Louvre (D)SP - Spot (E)MaterialSS - 316 Stainless SteelCJK150CanssLENSSTEPFDkcanFLcanFLFlucanHCLAccessories- Cable Joint Kit- 316 Stainless SteelCanister- Frost Lens- Deck Canister- Floor Lite Canister- Fluorescent Option- Fluorescent Canister- Hex Cell AdaptorFor an alternative LEDoption refer to page 10.4ABOrdering Example:FLLU SS - Floor Lite Louvre (D)316 Stainless SteelDFLSPFL SS-Floor Lite in 316 Stainless SteelSpot (E) with fluorescent option(Accessories ordered separately)CEHUNZA FACTORY130 Felton Mathew AveGlen InnesAuckland 1072New ZealandPh: 64-9-528 9471Fax: 64-9-528 9361hunza@hunza.co.nzwww.hunza.co.nzINTERNATIONAL CONTACTS:www.hunza.co.nz/contacts.phpSpecifications may change without notice.Manufactured in New Zealand.© 2010 Hunza Holdings Ltd.3.2

Luminaire ConstructionCNC machined from:Body:316 Stainless Steel 63.5mm (2½”) x9mm (11/32”). End cap - solid 316stainless steel 63.5mm (2½”) rod.Flange:316 Stainless Steel 90mm (3½”).MountingThe luminaire is pushed into thecanister and is held by two silicone“O” rings: Canss, FLcan, Flucan:Cast into concrete, brick, concreteblock, etc.Dkcan: mounted into wooden decks,wooden frames, etc.FeaturesLens:3mm (1/8”) clear tempered shatterresistant glass.Life Time Warranty.Gasket:0Silicone, iron impregnated 220 c0(428 f).Lamp Holders:0 0GU5.3 - 350 c (662 f) ceramic multi0contact lamp holder with 250 c0(480 f) teflon cables.Fluorescent:0 0E27 PET 210 c (410 f) base mount.E26 available in the USA.Accessories:Cable Joint Kit (Cat. CJK150)Not approved for USA /Canada.Deck Canister (Cat. Dkcan).Frosted Lens (Cat. LENSSTEPF).Floor Canister (Cat. FLcan).Fluorescent Canister PVC (Cat.Flucan).Fluorescent Option 8watt 240 volt(Cat. FL) IP66. (Note: Not forUSA/Canada).Hex Cell Louvre Adaptor (Cat. HCL)(Note: Supplied as standard forUSA/Canada).316 Stainless Canister for use inlime stone etc. (Cat. Canss).StandardsEN60598IP66/IP68UL1838Luminaire WeightSS .995kg (2lb 3oz)Fluorescent IP66SS 1.630kg (3lb 10oz)Power SupplyHUNZA Inground or Wall MountTransformer: not included.USA and Canada:HUNZA Wall Mount Transformer:not included.Luminaire: supplied withMR16 GU5.3 - 20 watt lamp max.LED - Refer sheet no. 10.4FluorescentE27 - 110/240 volt self ballastedlamp.USA and Canada:MR16 GU5.3 20 watt lamp max.LED - Refer sheet no. 10.4.MR16 ESX GU5.3012 volt 20 watt 10MR16 BAB GU5.3012 volt 20 watt 38MR16 GU5.312 volt 20 watt 6004000 Lux @ 200mm (8”)1000 Lux @ 400mm (16”)444 Lux @ 600mm (24”)1m(3’)2m(6’)3m(9’)700 Lux @ 650mm (26”)175 Lux @ 1300mm (51”)78 Lux @ 1950 (76”)1m(3’)2m(6’)3m(9’)450 Lux @ 1154mm (45”)112 Lux @ 2308mm (91”)50 Lux @ 3462mm (136”)1m(3’)2m(6’)3m(9’)These diagrams refer to the Spot Lite Flange (D) only.HUNZA FACTORY130 Felton Mathew AveGlen InnesAuckland 1072New ZealandPh: 64-9-528 9471Fax: 64-9-528 9361hunza@hunza.co.nzwww.hunza.co.nzINTERNATIONAL CONTACTS:www.hunza.co.nz/contacts.phpSpecifications may change without notice.Manufactured in New Zealand.© 2010 Hunza Holdings Ltd.3.2