Avalanche User Guide - Wavelink

Chapter 7: Managing Scan to Configure Profiles 63enabling either Use currently active Epoch or Use selected Epoch and selecting the starttime from the drop-down list.5 If you want to set a static IP address for the device, enable Assign static IP address andtype the IP Address, Subnet Mask and Gateway in the appropriate boxes.6 Click Save to save your changes.The profile is updated with the configured network settings.Adding Custom Properties for Scan to Config ProfilesCustom properties allow you to define specific properties that you want applied to the mobiledevice. An example of a custom property is location = Chicago. Once a custom propertyhas been applied to a device, you can use it as a selection criterion. You can apply customproperties to mobile devices through a Scan to Config profile.To add a custom property:1 From the Profiles tab, select the profile you want to configure.2 Click Edit.3 In the Properties area, click Add.The Edit Property dialog box appears.4 Type the Name and Value in the text boxes.5 Select whether the property is a Device or Network property.NOTE: Most properties will be device properties.6 Click OK.The task is added to the list in the Properties area. The property will be added when theprofile is applied on the mobile device.7 Save your changes.Adding a Registry Key to a Scan to Config ProfileYou can add registry keys and values to a profile. These keys will be added to the deviceregistry when the profile is applied.To add a registry key:1 From the Profiles tab, select the profile you want to configure.2 Click Edit.3 In the Registry Settings area, select where you want to add the key and click Add.