INSTALLATION AND OPERATION MANUAL - aesco

2. Read the measurement shown on the calipers.3. Press the p button adjacent to4. -b- -b- will be displayed.(SeeFig.4 )DYNAMICFor balancing standard steel or alloywheels using clip-on weights attachedto inner and outer wheel edges.5. Press the corresponding p qbuttons to enter thecorrect data. IMPORTANT NOTE: 10 mm should bedisplayed as 100 / 5-1/2 mm should be displayed as 55.C - Wheel DiameterThis is the diameter of the wheel at the rim flanges.Thismeasurement can be read on the tire sidewall. To enterWheel Diameter data, refer to the instructions below.1. Read the diameter of the wheel as shown on the tiresidewall. ( See Fig. 7 )STATICALU1ALU2This function is used if stick-on weightsare to be mounted to the center plane( hidden ) and not to either inner or outeredges of the wheel.This function is used if stick-on weightsare to be mounted to both inner andouter planes of the wheel.This function is used if stick-on weightsare to be mounted to the inner andcenter planes of the wheel.CALU3This function is used if stick-on weightsare to be mounted to the outer edgeand inner plane of the wheel.2. Press the p button adjacent to3. -c- -c- will be displayed.CFig. 74. Press the corresponding p q buttons to enter thecorrect data.STEP FOUR( Selecting Function )Prior to balancing, a specific function mustbe chosen for each particular wheel. Thefunction settings can be selected bydepressing the FUNbutton.ALU4This function is used if stick-on weightsare to be mounted to the inner edgeand outer plane of the wheel.STEP FIVE( Spin Mode / DYNAMIC, ALU1, ALU3, ALU4 )1. Once the correct wheel data and function have beenprogrammed, lower the hood to begin the spin mode.Before initiating the spin sequence, make sure that thehub nut is secure and engaged on the arbor threads byat least four (4) full turns.2. After the hood is lowered, or the START button isdepressed, the wheel will spin for approximately sixseconds then stop automatically.3. After the wheel stops, weight readings for each side ofthe wheel ( inner and outer ) will appear in the centerdisplay screen.4. Turn the wheel by hand until the weight position indicatorlights on the side marked INNER are fullyilluminated. This indicates the position specified by thebalancer for the inner weight position. ( See Fig. 8 )7