blackmagic atem 1 m/e production switcher - Imagecraft

78
Operating Your ATEM Switcher
To set up a DVE key on upstream keyer 1 on the broadcast panel:
Step 1. Press the KEY 1 next transition button to enable the keyer on the preview output. The system
control will dynamically navigate to the KEY 1 menu. You can manually navigate to the KEY 1
menu by pressing HOME > EFFECTS KEYS > KEY 1.
Step 2. Select the DVE menu button.
Step 3. The destination display will say key1fill. Select the fill source on the select bus. Since the key signal
is automatically created by the DVE engine, the cut source is ignored.
Step 4. To enable the mask and adjust the mask parameters, select the MASK MENU button.
Step 5. To enable the drop shadow or border and adjust their parameters, select the BORDER menu
button. For a description of DVE borders, refer to the table below.
Adjusting the x/y position of the DVE
From the broadcast panel, the x/y position of the DVE is adjusted with the joystick. If SHIFT is held while
moving the joystick, the DVE will be rotated around its center point.
DVE parameters
X Size Adjusts the horizontal size of the DVE.
Y Size Adjusts the vertical size of the DVE.
Rotation Spin the box around its center point with the Rotation adjustment knob.
Rot Rst Resets the rotation of the DVE.
DVE Rst Resets the DVE to full screen with no borders. If you ever lose track of the DVE
during adjustment, you can press reset to bring the DVE to full screen, then
squeeze it back into position.