blackmagic atem 1 m/e production switcher - Imagecraft
blackmagic atem 1 m/e production switcher - Imagecraft
blackmagic atem 1 m/e production switcher - Imagecraft
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
60<br />
Operating Your ATEM Switcher<br />
To perform a graphic transition on the broadcast panel<br />
Step 1. Select DVE as the transition type by pressing the SHIFT and DVE/WIPE buttons simultaneously.<br />
The DVE is illuminated green indicating that the DVE transition type is selected.<br />
If the DVE is already being used in an upstream key, the message DVE unavailable will be<br />
displayed and the DVE transition type will be unavailable for selection until the key is taken<br />
off air and off preview. Refer to sharing DVE resources below for more information.<br />
Step 2. From the system control menu buttons, push next until you are on the DVE Graphics menu,<br />
You can also navigate to the DVE menu by selecting TRANS > DVE PATTRN from the home<br />
menu and pushing next to get to the DVE Graphic page.<br />
Step 3. Select one of the two graphic mix buttons, depending on which way you want your graphic<br />
to spin across the screen.<br />
Step 4. Select the logo fill source and logo key source for the graphic from the select bus.<br />
Step 5. Set the rate and any other key parameters if required.<br />
Step 6. Perform the transition as an auto transition or manual transition from the transition control<br />
block.<br />
Description of graphic wipe parameters<br />
Fill Source The fill signal is the color graphic you will use on top of the transition.<br />
Key Source The key signal is a grayscale image that defines the region in the graphic that will<br />
be removed so that the fill signal can be correctly stacked on top of the wipe.<br />
Normal The normal direction moves the graphic from left to right.<br />
Reverse Reverse changes the direction so that is moves the graphic from right to left.<br />
FlipFlop When FlipFlop mode is toggled on, the transition changes between normal and<br />
reverse every time the transition is executed. The normal or reverse light indicates<br />
the direction of the next transition.<br />
Rate Rate specifies the length of the transition in seconds and frames. The rate can be<br />
adjusted using the rate knob or by entering a number on the number pad and<br />
pressing the set rate button.