Revolution sun shield instructions - BOB Trailers and Strollers

Revolution sun shield instructions(800) 893-2447 www.bobgear.com email- info@bobgear.com Ph: (208) 375-5171Fax: (208) 375-5172, BOB Trailers, Inc. 5475 Gage St. Boise, ID 83706Congratulations on yourpurchase of the BOB SunShield.It is designed to protect yourchild’s delicate eyes and skinfrom heat, glare andultraviolet (UVA/UVB) rays.Proper installation and carewill provide years of reliableservice.Before attempting toassemble or use your newSun Shield, read andunderstand theseinstructions completely toinsure proper assemblyand operation.If you are unclear on anypoint, contact your dealer orBOB before use.Warnings. This product is designedexclusively for use withBOB Revolution andStroller Strides strollers.It is not intended for usewith other strollers orproducts.. The Sun Shield is notdesigned to work withoptional Infant Car SeatAdapter and car seat.. Never leave childunattended.. The Sun Shield reducesthe exposure to sun andheat but does not eliminateit. Avoid exposing yourchild to prolonged sun andheat.. It is possible for smallinsects to enter through thesmall gaps between theshield and the stroller.. When not in use, keep outof reach of children.. When the Sun Shield isused, the rear canopy flapmust be repositioned asdescribed below to insureproper airflow andventilation for your child.OMA12ARearCanopyFlapAft Canopy SupportFully Rotated BackFig. 1 Canopy Supportsin positon.Cinch CordLock tightagainst CanopyFig. 2 Canopy DrawstringAdjustmentForwardCanopySupportFig. 3 Canopy Flap in PositionAir PassageFig. 4 Rear Vent UnobstructedInstallationinstructions:1. Set stroller Parking Brake(refer to Parking Brakesection of stroller Owner’sManual). Place the suncanopy into position toreceive the Sun Shield asshown in Fig. 1.2. Pull canopy draw stringin order to gather extramaterial under canopy.Cinch cord lock againstcanopy to retract and holdmaterial in place, as shownin Fig. 2.Very important: when theSun Shield is used, therear canopy flap must berepositioned as describedbelow to insure properairflow and ventilation foryour child.3. Locate rear canopy flapand fold forward. Attachcanopy flap Velcro on flapto respective Velcro mateon top outboard sides ofcanopy as shown in Fig. 3).Warning tag on rear canopyflap also describes andillustrates this critical step.4. Inspect opening at backof stroller to make sure theair passage between top ofseat back and canopy isunobstructed (see Fig. 4).We recommend recliningseat back slightly tooptimize airflow (refer toReclining Seat section ofstroller Owner’s Manual).5. Place Sun Shield on thestroller so the rear flapdrapes over back (betweenthe handlebars) and theseam above the window isaligned with the forward SunCanopy support (see Fig.5).6. Stretch the elastic cordon each side under eachrespective black shock knobas shown in Fig. 6. Thereis an opening mid way upeach side (with silverreflective fabric on eachend) where the elastic cordis exposed.7. Attach each looped endof the elastic cords(protruding out sides of backflap) around each blackshock knob on respectiveElasticCordEndLoopAlign SunShieldSeam withForwardCanopySupportFig. 5 Shield placed on CanopyElastic LoopAround BlackShock KnobFig. 6 Elastic cord attachmentSide Edgesunder FrameSilverReflectiveFabricElastic CordUnder BlackShock KnobFront Edge underplastic Lip of NoseFig. 7 Sun Shield correctlyinstalled on Revolution.P1

side of stroller, as shown inFig. 6 (right side shown).The cord locks allow theloop to be enlarged orreduced, thereby adjustingthe tension.8. Stretch and hook thefront elastic edge of the SunShield evenly under the lipof the plastic nose on thestroller. Keep edge abovered swivel lockout knob(see Swivel Lockout sectionof Owner’s Manual).Position BOB Logo incenter over nose of thestroller (Fig. 7).9. Stretch each elasticedge of the Sun Shield androute under eachrespective side of frametube as shown in Fig. 7.10. Center rear flap of SunShield on stroller handlebar.Inspect air passage abovestroller seat. Make sure airopening is not obstructed(Fig. 8).11. To place passengerinto the stroller, pull the frontof the Sun Shield off thenose of stroller, then lift up,stretch and roll over theforward edge of strollercanopy as shown in Fig. 9.This will temporarily holdthe Sun Shield out of yourway while you place thechild into the seat.12. Once your child issecured in the safetyharness (refer to yourstroller Owner’s Manual,Seat Safety Harnesssection), release the SunShield from canopy and resecureunder the lip on thestroller nose and underframe sides. Fig. 7 showsa Revolution Sun Shieldcorrectly installed.Air Passage unobstructedFig. 8 Rear Flap centered on bar.LIMITED WARRANTY:BOB Trailers Inc. takes pridein its workmanship andstrives to manufacture thebest products possible.Therefore, we warranty theRevolution Sun Shieldagainst defects in materialand workmanship subject tothe conditions listed below.Since no product isindestructible, it does notcover defects attributable toor resulting from normal wear,abuse or alteration.. The Revolution Sun Shieldis warranted for one yearfrom the date of originalpurchase.. Warranty is only valid forthe original purchaser.. Proof of purchase isrequired to exercise thiswarranty.. Labor and freight chargesare not included.. Normal wear, neglect,abuse, accidents, improperuse are not covered by thiswarranty.. Warranty claims must bemade through anauthorized dealer.. This warranty is limited tothe repair or replacementof the defective part. BOBshall in no event beresponsible forconsequential or specialdamages.. This limited warranty is theonly express or impliedwarranty applicable toBOB. Any impliedwarranties, includingwarranties ofmerchantability and fitnessshall be limited in scopeand duration in accordancewith this limited warranty.CAREINSTRUCTIONS:Hand wash cold and hangdry. Do not dry clean, iron,or place in dryer.Fig. 9 Sun Shield shown placedover Forward Canopy Supportfor loading & unloading.OMA12AP2