Quidway AR 28 Series Routers Installation Manual.pdf - Index of

More documents

Recommendations

Info

$t.-l ,\l$

Installation ManualQuidway AR 28 Series RoutersChapter 5 Startup and Configuration of the Router5.1.3 Startup ProcessI. BootAfter the startup of the router, Boot ROM program will be run first and the followingsystem information will be displayed on the terminal screen: Note:The interfaces displayed on the terminal could vary slightly with different versions of Boot ROM.Router start booting,(V2.00)Starting at 0x1500000...********************************************* ** Quidway Series Routers Boot ROM, V9.03 ** *********************************************Copyright(C) 1997-2003 by HUAWEI TECH CO., LTD.Compiled at 17:11:06 , Aug 19 2003.Testing memory...OK!256M bytes SDRAM32768k bytes flash memoryHardware Version is MTR 2.0CPLD Version is CPLD 1.0Press Ctrl-B to enter Boot MenuPress and the system will enter the Boot menu. Otherwise, the system willenter the program decompression process. Note:• After “Quidway Series Router Boot ROM, V9.03” appears, “Quidway start booting” will disappearimmediately.• The system enters the Boot menu only if is pressed immediately (within seconds) after thestatement “Press Ctrl-B to Enter Boot Menu...” appears.5-5
Installation ManualQuidway AR 28 Series RoutersChapter 5 Startup and Configuration of the RouterII. System decompression and initializationThe screen will display:Now system is self-decompressing...System now is starting...Press ENTER to get startedPress and the screen will display:[Quidway]This prompt indicates that the router has entered the system view, and now the routercan be configured.5.2 Configuration Fundamentals of the Router5.2.1 Basic Configuration StepsIn general, the configuration steps are as follows:Step 1: Before configuring the router, the networking requirements should be madespecific, which include networking purpose, the role of the router in the network, thedivision of subnets, WAN type and transmission medium, the network security policyand reliability.Step 2: Based on the above requirements, draw a clear and integrated networkingdiagram.Step 3: Configure the WAN interface of the router. First, configure the physicaloperating parameters (e.g., the operating mode of the serial interface, baud rate andsynchronous clock) of the interface according to the transmission medium of the WAN.For the dial-up interface, the user also needs to configure DCC parameters. Then,configure the link layer protocol encapsulated on the interface and the related operatingparameters according to the WAN type.Step 4: Configure the IP addresses or IPX network numbers of all the interfaces on therouter according to the division of the subnets.Step 5: Configure the routes. If it is necessary to enable a dynamic routing protocol, theuser should configure the related operating parameters of the protocol.Step 6: If special security is required, perform the security configuration for the router.Step 7: If special reliability is required, perform the reliability configuration for the router.5-6
Page 1 and 2:
Chapter 1 Overview ................
Page 3 and 4:
6.2.3 Replacing the DIMM ..........
Page 5 and 6:
Quidway AR 28 Series RoutersInstall
Page 7 and 8:
About This ManualVersionThis manual
Page 9 and 10: II. GUI conventionsConventionDescri
Page 11 and 12: Installation ManualQuidway AR 28 Se
Page 59: Installation ManualQuidway AR 28 Se
Page 87: Installation ManualQuidway AR 28 Se
show all

Quidway AR 28 Series Routers Installation Manual.pdf - Index of

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?