TeleWell TW-EA200 & TW-EA500 ADSL modeemi/ reititin/palomuuri ...

TW-EA200/500 ADSL modeemi/reititin ja palomuuri2.3 The Rear PortsThe rear panel of the Router provides access to the AC power adapter cord connection as well asthe port connections.TW-EA500TW-EA2002.4 CablingThrough USB PortThe product can be used as a Network Adapter on your PC. That means you do not have toinstall a network adapter first on your PC before connecting the ADSL Modem/Router. Justconnect the supplied USB cable to the USB port of the ADSL Modem/Router and connect theother end to the PC.Make sure that your ADSL Modem/Router and PC are turned on. On the front of the product is abank of LEDs. As a first check, please verify that the PWR, USB and ADSL SYN LEDs are lit.As long as the cables are connected and the LEDs are lit normally, follow section “3.1.1Installing the USB Driver” below to setup this device.Through Ethernet PortThe Router may be connected to any 10/100BASE-T Ethernet LAN or Ethernet concentratingdevice. Connection to an Ethernet concentrating device such as a switch or hub should usestandard twisted-pair cable with RJ-45 connectors. The dedicated RJ-45 port on the Router are acrossed (MDI-X) connection ports. Follow standard Ethernet guidelines when deciding whattype of cable to use to make this connection.Use straight-through cable when connecting the Router to a normal (MDI-X) port on a switch orhub. Use crossed cable when connecting it to an uplink (MDI-II) on a hub or switch. Whenconnecting the Router directly to a PC or server use a straight-through cable. A valid connectionwill be indicated by the Link LED indicator corresponding to the connected port.As long as the cables are connected and the LEDs are lit normally, follow chapter 3“Configuration” below to modify the network settings.6