TruVision DVR 60 User Manual - Interlogix

5BChapter 6: Configuring the live mode displayTable 12: Description of the Monitor setup screenOptionDevice nameDevice addressVGA resolutionTransparency menuMonitor standardMonitor brightnessMouse pointer speedScaling monitor A / BPassword requiredDescriptionThe name to use for the DVR.The device number to use for the DVR when programming the remotecontrol or keypad.Define the VGA resolution.Select one of the options from the drop-down list. Default is1024×768/60 HZ.Modify the transparency of the menus on-screen relative to the backgroundto make the menu screens easier to read or less prominent on-screen.Default is non-transparent.Select one of the options from the drop-down list.The video standard used is auto detected.Modify the video standard used to PAL or NTSC.Modify the video output brightness.Modify the speed of the mouse pointer.Enable/disable the monitor display of the main (A) and spot (B) monitorssize to accommodate for differently sized monitors.Enable/disable system password.DVR name and addressThe DVR name is the name that appears on-screen such as during start up.When you use the IR remote control or keypad to operate the TVR 60, theTVR 60 must have a device address (bus ID). The default device address is 255for a remote control.If there is more than one DVR used, each device must have its own uniquedevice address as otherwise the IR remote control will control all the DVRstogether.To configure the device name and address:1. Enter the Display Settings screen by selecting Display in the main menu.2. Click the Monitor tab. The Monitor screen appears.3. In the Device Name box, enter a name for the TVR 60 unit. You can enter upto 38 characters.4. Click the Device address edit box. The virtual keyboard appears. Enter anumeric value and click Enter. Up to eight digits can be entered. Defaultaddress for the remote control is 2555. Click the Apply button to save the settings.6. Click OK to return to the main menu.40 TruVision DVR 60 User Manual