TruVision DVR 60 User Manual - Interlogix

Chapter 3Getting startedTurning on and off the DVRBefore turning the power on connect at least one monitor to the video out or theVGA interface. Otherwise, you will not be able to see the user interface andoperate the device. Also connect at least one camera.The TVR 60 auto-detects the video mode (PAL or NTSC) on startup.The TVR 60 is equipped with a universal power supply that will auto-sense110/240 V, 60/50 Hz.Note: It is recommended that an uninterruptible power supply (UPS) is used inconjunction with the device.To turn on the DVR:Turn on the DVR using the power switch on the rear panel. Once the TVR 60 ispowered up, the indicator bar on the front panel will light up green. All connectedcameras are displayed on-screen. The TVR 60 automatically begins recording.To turn off the DVR:Turn off the DVR using the power switch on the rear panel.Using the Setup WizardThe TVR 60 has an express installation wizard that lets you easily configurebasic DVR settings when first used. It configures all cameras simultaneously.The configuration can then be customized as required.By default the Setup Wizard will start once the DVR has loaded, as shown inFigure 8 on page 20. The Setup Wizard will walk you through some of the moreimportant settings of your DVR.Note: After the system is set up, you can uncheck the “Start wizard” box. Thesetup wizard is then no longer started automatically.TruVision DVR 60 User Manual 19