TruVision DVR 60 User Manual - Interlogix

12BChapter 13: Configuring network settings9. Click OK to save.Configuring an NTP serverA Network Time Protocol (NTP) Server can also be set up on your DVR to keepthe date and time current and accurate.To set up an NTP server:1. Enter the Network Settings screen by selecting Network in the main menu.2. Click the Advanced tab.3. Click Setup (next to NTP) to enter the NTP screen.4. Check the NTP box to enable feature.5. Define NTP settings by selecting one of the following options:• Synchronize Interval: Time in minutes to synchronize with NTP server.• NTP Address: IP address of NTP server.• NTP Port: Port of the NTP server.6. Click OK to save and exit menu.Configuring a remote alarm hostIf a remote alarm host set, the DVR sends a signal to the host when an alarm istriggered. The remote alarm host must have the TruVision Navigator serversoftware installed.To set up a remote alarm host:1. Enter the Network Settings screen by selecting Network in the main menu.2. Click the Advanced tab.3. Enter Alarm Host IP and Alarm Host Port.Alarm Host IP represents the IP of the remote PC where the Network VideoSurveillance software installed. The Alarm Host Port value must be the sameas software’s alarm monitor port. Default port is 7200.TruVision DVR 60 User Manual 101