UNDERWAY REPLENISHMENT NWP 4-01.4 - Historic Naval Ships ...

NWP 4-01.42. Attach the inhaul to the STREAM trolley. Reevethe highline through the trolley. Insert theouthaul pendant in the trolley (if required).3. Install the Mk 5 strongback, cargo drop reel, orcargo hook onto the trolley. The drop reel is installedwith the brake release lanyard aft.4. Secure the 1-3/8-inch (34.9 mm) STREAM pelicanhook to the highline. Use a 7/8-inch (22.2mm) safety anchor shackle.5. Install the stopper plate on the highline end fitting.6. Fake out the messenger/outhaul. Stop off thehighline to the messenger beckets. Stop off firstto the shackle on the highline end fitting, thenuse two stops on the highline about 12 inches(30.4 cm) apart. (Refer to Figure 6-22).7. Attach the inboard end of the messenger/outhaulto the trolley. Shackle the inboard end of theouthaul pendant on the trolley, if one was rigged.Use a 7/8-inch (22.2 mm) safety anchor shackle.8. Attach the station phone line and the lead line messengerfor the phone/distance line (if required).9. Ensure that all required working and repair toolsand safety equipment are on station and that personnelare briefed, properly dressed, and onstation.(2) RECEIVING SHIP1. Attach the fairlead block for the messenger/outhaul below and close to the long link for theSTREAM pelican hook on the highline. Attach asecond fairlead block located for proper fairleadto line handlers.2. Ensure that all required working and repair toolsand safety equipment are on station and that personnelare briefed, properly dressed, and onstation.3. Ensure that a sufficient number of personnel areon station for tending the outhaul; minimum of10 line handlers.4. Provide an easing-out line on station. See paragraph2.2.11.5.8.4.4 Passing Personnel STREAM With Hand-Tended Outhaul(1) DELIVERY SHIP1. For Navy standard hauling winch only:a. Secure outhaul whip to appropriate padeye.b. Vent air from outhaul drum clutch by movingmanual vent valve V-21 (see Figure 8-7) up tothe VENT CLUTCH position.c. Place MASTER STATION SELECTORSWITCH in BOTH DRUMS ON position.d. Slowly move SPEED control handle in thehaul-in direction to bring the trolley to the transferhead, then to the haul-in HALF SPEEDdetent and leave in detent.2. For inhaul winch with slip clutch only: Haul into bring the trolley to the transfer head, thenplace winch in tension control.Inhaul winch with slip clutch should be intension control before the transfer head ismoved.3. Send over the shot line attached to the messenger.(2) RECEIVING SHIPCAUTION1. Receive the shot line and haul in. When the messengercomes aboard, install the messenger inthe fairlead blocks and continue to haul in.2. When the station phone line and the lead linemessenger for the phone/distance line comeaboard, disconnect them and move them clear ofthe area.3. Attach the phone/distance line to the lead line messengerand signal the delivery station to haul in.4. Connect the station phone and establish voicecommunication with the delivery station.5. Continue to haul in the messenger/outhaul.8-7 ORIGINAL