UNDERWAY REPLENISHMENT NWP 4-01.4 - Historic Naval Ships ...

NWP 4-01.49. Ensure that all necessary working and repair toolsand safety equipment are on station and that personnelare briefed, properly dressed, and on station.(2) RECEIVING SHIP. (See Figure 6-23.)1. Install the fairlead block for the messenger.2. Install the deck fairlead snatch blocks.3. Ensure that all necessary working and repairtools and safety equipment are on station andthat all personnel are briefed, properly dressed,and on station.4. At a pendant receiving station, rig the pendant.5. Provide an easing-out line on station. See paragraph2.2.11.5.6.10.2 Passing STREAM With TravelingSURF(1) DELIVERY SHIP1. With the STREAM transfer head in the down position,take up slack, switch the inhaul winch totension control and the outhaul winch to speedcontrol, and then raise the transfer head.The inhaul winch must be in tension controlbefore moving the STREAM transfer head,when rigging or unrigging.2. Send over the shot line attached to the messenger.(2) RECEIVING SHIPWARNING1. Receive the shot line and haul in. When the messengercomes aboard, install the messenger in therigging and fairlead blocks and continue to haul in.2. When the station phone line and the lead linemessenger for the phone/distance line comeaboard, disconnect them and move them clear ofthe area. Continue heaving in on the stationphone line until the delivery station signalsavast, and then tend.3. Attach the phone/distance line to the lead linemessenger and signal the delivery station toheave around.4. Connect the phone and establish voice communicationwith the delivery station.5. Continue to haul in the messenger.(3) DELIVERY SHIP1. Haul in the lead line messenger. When the zero endof the phone/distance line is aboard, attach it to theoutermost rail, clear of the transfer station. Fakedown the lead line messenger free for running anddisconnect it from the phone/distance line.2. Raise the STREAM transfer head to the full-upposition. Pay out the highline.3. Ensure the highline ASD is ON. When the ASDis installed outboard of the ram tensioner, theASD will pull wire rope through the ramtensioner and prevent fouling of the wire on thehighline winch.WARNINGWhen the ASD is installed inboard of theram tensioner, the ASD will prevent foulingof wire on the highline winch. It may benecessary for personnel to pull the slackhighline through the ram. This will assistpersonnel at the receiving station in haulingthe highline across.(4) RECEIVING SHIP. (See Figure 6-23.)1. Haul in the messenger until the highline comesaboard.NoteBefore attaching the STREAM pelicanhook, make sure that the messenger is nottwisted around the highline. If it is twisted,the SURF will not haul in close enough to beconnected to the bail of the STREAMpelican hook.2. Attach the STREAM pelican hook to the longlink on the padeye or pendant. Attach it with thebail down. (Cut the first stop if necessary.) Usethe correct cotter pin (see Figure 2-21).3. Install the easing-out line through the pelicanhook’s long link and secure.6-37 ORIGINAL